Most railroad cars employ a natural ventilation cooling method. For this reason, severe problems occur in the control devices for the railroad cars due to the heat generated by the high-power switching loss. Therefore, the traction inverter for the railroad car requires a control method that can reduce the switching loss. In this paper, we propose a control method for an interior permanent magnet synchronous motor in consideration of the driving conditions of the railroad cars. The proposed method combines a variable switching frequency-based synchronous pulse width modulation control method, a flux-weakening control method that considers the maximum voltage modulation index, and an optimized over-modulation method. Through the proposed method, the utilization rate of the DC-link voltage can be maximized while lowering the switching frequency of the traction inverter as much as possible, and the high-performance current control can be performed in the entire speed region of the railroad car. The validity and effectiveness of the proposed method are verified by the simulation results and the experimental results.
In the flux-weakening control, Interior Permanent Magnet Synchronous Motor (IPMSM) for traction motor of Hybrid Electric Vehicles (HEVs) makes it possible to operate at the region of high speed and assists the power, which improve the efficiency of HEV. If the magnetic flux generated by the rotor does not reduced enough in the constant power region, the current controller is saturated and then the transient response of the current controller will be unstable. It leads to decreases the efficiency of the vehicles because the traction motor is operated as load. In order to solve this problem, the method that flux-weakening is operated under rated speed of the IPMSM is commonly used. However, it causes to reduce the torque due to the limitation of the phase current. This paper presents the current control method in the constant power region to avoid the saturation of the current controller. The simulation and experimental results are represented for the verification of the presented method.