Adilson S. Cardoso

Adilson S. Cardoso

Auto-generated profile, based on publicly available information

Adilson S. Cardoso

Raytheon, Atlanta, GA, USA

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
10 September 2020 in IEEE Microwave and Wireless Components Letters
Verified
Journal Article
Closed access
CCClifford D. Cheon
Clifford D. Cheon
MCMoon-Kyu Cho
Moon-Kyu Cho
SRSunil G. Rao
Sunil G. Rao
ACAdilson S. Cardoso
Adilson S. Cardoso
JCJeffrey D. Connor
Jeffrey D. Connor
JCJohn Cressler
John Cressler
This letter presents new wideband single-pole double-throw (SPDT) RF switches utilizing SiGe heterojunction bipolar transistors (HBTs) for both series and shunt switches. SiGe HBT, when used as a series switch, exhibits small parasitic components compared to bulk CMOS, which improves insertion loss at high frequency and supports wider bandwidth. For a series switch, three configurations are proposed: using the collector as an input (CI), using the emitter as an input (EI), and using a combination of the two in an antiparallel (AP) fashion. While all three configurations exhibit similar performance, the SPDT switch with the EI SiGe HBT exhibits the best insertion loss and isolation achieving dc-to-above 110-GHz bandwidth, 2.5 dB of insertion loss, and 27.3 dB of isolation at 60 GHz. The SPDT switch with AP SiGe HBT pair exhibits the highest linearity, with 15.6 dBm of input 1-dB compression point (IP 1 dB) at 10 GHz. With 0.61 mW of power dissipation, these new SPDT switches using SiGe HBTs exhibit similar performance to silicon-on-insulator (SOI) CMOS while obtaining higher power capability among conventional series-shunt SPDT designs.

9 September 2021 in IEEE Transactions on Circuits and Systems II: Express Briefs
Verified
Journal Article
Closed access
CCClifford D. Cheon
Clifford D. Cheon
SRSunil G. Rao
Sunil G. Rao
WLWonsub Lim
Wonsub Lim
ACAdilson S. Cardoso
Adilson S. Cardoso
MCMoon-Kyu Cho
Moon-Kyu Cho
JCJohn Cressler
John Cressler
This brief presents a wideband, low insertion loss, high attenuation range digital step attenuator (DSA) implemented using SiGe HBTs. In a switched-type topology, the off-state capacitances ( $\text{C}_{OFF}$ ) in both reference and attenuation states cause different poles and zeros, which trigger amplitude and phase errors and limit the operating bandwidth. To achieve wide bandwidth, methods to relocate poles and zeros to the highest possible frequencies in both states are investigated. In the reference state, minimizing the size of the shunt switching transistors extends the bandwidth. In the attenuation state, switching in a capacitor at the base of an anti-parallel (AP) SiGe HBT pair series switch reduces the effective $\text{C}_{OFF}$ , enhancing the bandwidth. The proposed techniques facilitate the realization of a 16-dB attenuator cell to support wide bandwidth and offer lower insertion loss than conventional cascaded 8-dB cell designs. Fabricated in 130-nm SiGe BiCMOS technology, the proposed DSA with an attenuation range of 31.5 dB in 0.5 dB steps operates from DC to 67 GHz and achieves an insertion loss lower than 7.8 dB. The RMS amplitude error is less than 0.4 dB above 1 GHz, while the RMS phase variation is less than 13.1°.

13 December 2018 in IEEE Transactions on Nuclear Science
Verified
Journal Article
Closed access
AOAnup P. Omprakash
Anup P. Omprakash
AIAdrian Ildefonso
Adrian Ildefonso
ZFZachary E. Fleetwood
Zachary E. Fleetwood
George TzintzarovGeorge Tzintzarov
George Tzintzarov
ACAdilson S. Cardoso
Adilson S. Cardoso
JCJohn D. Cressler
John D. Cressler

29 October 2018 in IEEE Transactions on Device and Materials Reliability
Verified
Journal Article
Closed access
ISIckhyun Song
Ickhyun Song
ACAdilson S. Cardoso
Adilson S. Cardoso
HYHanbin Ying
Hanbin Ying
MCMoon-Kyu Cho
Moon-Kyu Cho
JCJohn Cressler
John Cressler
The cryogenic performance of radiation-hardened radio-frequency (RF) low-noise amplifiers (LNAs) is presented. The LNA, which was originally proposed for the mitigation of single-event transients (SETs) in a radiation environment, uses inverse-mode silicon-germanium (SiGe) heterojunction bipolar transistors (HBTs) in its core cascode stages. In this prototype, the upper common-base SiGe HBT is configured in inverse mode for balanced RF performance and reduced SET sensitivity. In order to better exploit the inverse-mode LNAs in a variety of extreme-environment applications, the RF performance of the LNA was characterized using liquid nitrogen to evaluate cryogenic operation down to 78 K. While the SiGe LNA exhibits acceptable RF performance for all temperature conditions, there is a noticeable gain drop observed at 78 K compared to the conventional forward-mode design. This is attributed to the limited high-frequency performance of an inverse-mode SiGe HBT. As a guideline, compensation techniques including layout modifications and profile optimization are discussed for the mitigation of the observed gain degradation.

10 April 2026 in IEEE Microwave Magazine
Verified
Journal Article
Closed access
JBJennifer Byford
Jennifer Byford
CBCynthia Baker
Cynthia Baker
ACAdilson Cardoso
Adilson Cardoso
GDGerald DeJean
Gerald DeJean
Provides society information that may include news, reviews or technical notes that should be of interest to practitioners and researchers.