10 November 2021 in IEEE Transactions on Microwave Theory and Techniques
The effort to confine the electromagnetic field by silicon passive metadevices has made the design of an on-chip wideband sub-terahertz (sub-THz) I/O redriver feasible, paving a new way toward energy-efficient and crosstalk-immune ON–OFF keying (OOK) communications. Two metadevices, namely spoof surface plasmon polaritons (SPPs) metawaveguide and split-ring resonator (SRR), are exploited to build the sub-THz low-crosstalk silicon channel and high-ON–OFF-ratio modulator, respectively. A sub-THz signal source combining the merit of spoof SPPs and SRR is introduced. A 140-GHz dual-channel redriver composed of these metadevices is fully integrated in a 65-nm CMOS technology. The redriver realizes both 2 7 –1 and 2 31 –1 13.5 Gb/s/lane for dual-channel OOK modulation. The measured energy efficiency is 2.6 pJ/bit/lane and the bit error rate (BER) is ≤10 −12 , demonstrating a crosstalk-immune sub-THz I/O system. The power consumption is 35.1 mW/lane and the active area of the redriver is 0.23 mm 2 .
24 April 2019 in IEEE Transactions on Very Large Scale Integration (VLSI) Systems
In an effort toward high-speed and low-power I/O data link in the future exascale data server, this paper presents a signal source and a modulator in the D-band. The split-ring resonator (SRR) structures are used to boost both the signal power and the extinction ratio (ER). The modulator manifests itself as a compact SRR whose magnetic resonance frequency can be modulated by high-speed data. Such a magnetic metamaterial achieves a significant reduction of radiation loss with high ER by stacking two auxiliary SRR unit cells with interleaved placement. The high-Q tank for oscillation is realized by a stacked SRR decorated with slow-wave transmission line (T-line) for electric field confinement. A four-way power-combined fundamental 80-GHz coupled-oscillator network is magnetically synchronized by the slow-wave T-line, which is frequency doubled to 160 GHz. Fabricated in the 65-nm CMOS process, the measured results show that: 1) the modulator achieves 3-dB insertion loss at the on-state with 43-dB isolation at the off-state, leading to a 40-dB ER at 125 GHz within an area of only 40 μm x 67 μm and 2) the signal source achieves 6.3% frequency tuning range (FTR) with 3.7-mW peak output power at 160 GHz within 0.053-mm² active area. It has a measured phase noise of -105 dBc/Hz at 10-MHz offset, 5.5% dc-to-RF power efficiency, 70.1-mW/mm² power density, FOM of -171 dBc/Hz, and FOMT of -172.7 dBc/Hz.
14 November 2019 in IEEE Transactions on Antennas and Propagation
This article presents a 1-D frequency-diverse guided-wave imaging technique based on a surface-wave Goubau line. It employs frequency diversity to capture spatial information of the scatterers with an almost real-time speed, which is much faster than mechanical scanning or electronic scanning approaches. The surface-wave Goubau line is used because it provides more independent measurement modes than conventional transverse electromagnetic (TEM) transmission lines. Compressed sensing algorithms are employed to recover the spatial distributions when some sparse metal scatterers are placed above the line. The proposed technique is validated by four numerical examples and two experimental validations, where both narrow scatterers and wide scatterers are considered. It shows that the proposed technique is able to reconstruct scatterer position within an error of 1 mm, about 1/30 space wavelength at the center frequency 10 GHz. It is also able to identify two close scatterers until their distance reduces to 1 mm. This guided-wave technique, although applicable to very near-field detection only, can find broad applications in localization, field measurement, and fault detection.
9 May 2019 in IEEE Microwave and Wireless Components Letters
In this letter, a single-layer electronically steerable leaky-wave antenna based on the Goubau line is presented. The modulation units consist of metalines connected by periodically loaded switchable p-i-n diodes and its biasing circuit. These p-i-n diodes are used as switches to dynamically control the modulation periodicity, and the antenna featuring low profile can, therefore, provide tunable beam-scanning angles at a fixed frequency. Measured antenna prototype demonstrates beam-steering capability of 74° at 4.35 GHz.
1 September 2025 in IEEE Transactions on Electron Devices
This study investigates the application of silicon-on-insulator (SOI) substrate-based pseudo-inverter (Ψ-inverter) and pseudo-MOS (Ψ-MOS) for NO2 and NH3 gas detection. Experimental results demonstrate that Ψ-inverter, characterized by high internal gain, consistently exhibits superior sensitivity compared to the Ψ-MOS device across various channel thicknesses for both target gases. At 1-ppm concentration, Ψ-inverter achieved remarkable sensitivities of 1248% and 83.9% for NO2 and NH3, respectively, surpassing Ψ-MOS sensitivity by factors of 102.5 and 19.7. In addition, Ψ-inverter configuration offers the advantage of direct voltage signal output, facilitating practical implementation.