We demonstrate the single photon counting mode at 405 and 850 nm with stoichiometric TiN-based microwave kinetic inductance detectors realized on a sapphire substrate and operated at bath temperatures over 300 mK. The detectors use single 15–25 nm-thick TiN layers featuring a critical temperature in the 2–3 K range. We found that the energy-resolving power R=E/ΔE exhibits an optimum with bath temperature, occurring in the 300–450 mK range, which can be almost double compared to those obtained at the lowest temperatures. Furthermore, the single photon regime is observed up to 700 mK. In addition to a high-temperature operation, the single stoichiometric layer would allow achieving a better uniformity in the critical temperature and, thus, kinetic inductance, compared to the often desired ∼1 K sub-stoichiometric TiN.
Superconducting flip-chip interconnects are crucial for the three-dimensional integration of superconducting circuits in sensing and quantum technology applications. We demonstrate a simplified approach for a superconducting flip-chip device using commercially available indium microspheres and an in-house-built transfer stage for bonding two chips patterned with superconducting thin films. We use a gold-passivated niobium or niobium nitride layer as an under-bump metallization (UBM) layer between an aluminum-based superconducting wiring layer and the indium interconnect. At millikelvin temperatures, our flip-chip assembly can transport a supercurrent with tens of milliamperes, limited by the smallest geometric feature size and critical current density of the UBM layer and not by the indium interconnect. We show that the pressed indium interconnect itself can carry a supercurrent exceeding 1 A due to its large size of about 500 μm diameter. Our flip-chip assembly does require neither electroplating nor patterning of indium. The assembly process does not need a flip-chip bonder and can be realized with a transfer stage using a top chip with transparency or through-vias for alignment. These flip-chip devices can be utilized in applications that require few superconducting interconnects carrying large currents at millikelvin temperatures.
13 December 2023 in Journal of Low Temperature Physics
In this paper, we investigate the quasi-particle (QP) relaxation of strongly disordered superconducting resonators under optical illumination at different bath temperatures with the Rothwarf and Taylor equations and the gap-broadening theory described by the Usadal equation. The analysis is validated with various single-photon responses of titanium nitride (TiN) microwave kinetic inductance detectors under pulsed 405 nm laser illumination. The QP relaxation in TiN is dominated by QPs with energy below the energy gap smeared by the disorder, and its duration is still inversely proportional to the QP density. The QP lifetime versus temperature can be fitted. The relaxation of the resonator can be further modeled with QP diffusion. The fitted QP diffusion coefficient of TiN is significantly smaller than expected. Our result also shows a significant increase in QP generation efficiency as the bath temperature increases.
In this paper, we investigate the single photon response from the reflection of the microwave kinetic inductance detector (MKID) array. Reflection measurements are carried out using two configurations: one is measured simultaneously with the transmission, and the other is obtained with a single-ended MKID array terminated with an open load. Compared with the transmission, reflection measurements significantly reduce the readout noise of the single-ended MKID array. This is also reflected in the improvement of the median energy resolving power by around 20%–30% under pulsed photon illumination at λ = 405 nm, mainly due to an increase in the size of the resonance circle on the IQ plane. This method has the potential to be used to read out large MKID arrays.