12 October 2022 in IEEE Transactions on Electromagnetic Compatibility
The operational environment of modern electronic systems may include multiple frequency electromagnetic disturbances. However, immunity measurements usually employ single-frequency continuous waveforms (i.e., single-tones ). The performances of two oscillator circuits with different topologies (one simulated and one measured) were used as case studies to investigate immunity to simultaneous single-tone disturbances (i.e., multitones ) using probabilistic Bayesian network models. For the multitone analysis, the noisy-OR model was first used to identify the type of causal interactions between simultaneously occurring single-tones. Probabilistic theories derived from the recursive noisy-OR model, which inherits the independence assumptions of the noisy-OR and any known causal dependence between simultaneously occurring single-tones, were then used to predict the probability of higher order multitone failures. For the two case studies, the probability of three-tone failures was estimated using the single-tone and two-tone failure probability values. An improved adaptive recursive noisy-OR model was also proposed to overcome the practical difficulties of obtaining multitone failure probabilities, from either simulations or measurements.
8 August 2022 in IEEE Access
The reliable operation of an integrated circuit can be affected by environmental changes, such as of multiple frequency electromagnetic (EM) disturbances and temperature variations. This paper compares the performance of two oscillator circuits, namely a current-starved voltage controlled oscillator and a ring oscillator integrated into a chip, in terms of their immunity to multitone direct power injection while under the influence of thermal stress. The objective is to demonstrate by the means of measurements the synergistic effect caused by multitone EM disturbances in a test chip, in contrast to the conventional single-tone EM disturbances. Moreover, the multitone immunity levels of integrated blocks with different architectures but similar functionality are analyzed at extreme temperature deviations. Bayesian networks (BN) are applied in order to visualize the probability of circuit failure due to multitone disturbances and temperature influence. Additionally, noisy-OR and improved-adaptive-recursive-noisy-OR (I-ARNOR) probabilistic models are implemented to identify the types of causal interactions (i.e. inhibition and positive causality) between multitone disturbances and to predict the probability of failure due to higher order multitone disturbances, respectively.
17 May 2022 in IEEE Letters on Electromagnetic Compatibility Practice and Applications
The performance of two oscillator circuits, namely a current-starved voltage controlled oscillator and a ring oscillator, is compared with respect to multi-tone direct power injection (DPI). The objective is to investigate the impact of causal dependence between multi-tones on the immunity levels of integrated blocks with different architectures but similar functionality. The multi-tone immunity analysis performed using the probabilistic noisy-OR model reveals an increase in the probability of failure due to electromagnetic interference relatively to single-tone EM disturbance. The proportions of inhibition and positive causality, as well as the mean degree of synergy ( DoS ) caused by multi-tone EM disturbances, are extensively compared for both oscillator circuits.
1 May 2020 in IET Science, Measurement & Technology
Validation and verification activities are essential enablers for the practical application of computational electromagnetics (CEM) models in industrial applications, but these terms are widely confused or merged. Furthermore, concepts such as the accuracy and precision of measurement results are often poorly understood. As model accuracy is most commonly judged against measured results there is a strong case to establish a well‐defined vocabulary for describing the accuracy of CEM models that is both consistent with, and complementary to, the existing vocabulary associated with measurements. In order to help clarify the situation, this study identifies the difference between validation and verification in relation to CEM, suggests a mapping between CEM and measurement processes, collates a number of relevant definitions from existing measurement standards, and proposes new and complementary definitions that relate specifically to CEM simulation. It is considered that the proposed vocabulary could help to avoid misunderstandings between the test and modelling domains and eliminate ambiguity in standards relating to CEM validation and verification. In addition, the terminology presented here could also be readily adapted to help develop or clarify similar standards for other physics‐based simulation domains, and perhaps even for more general mathematical modelling applications.