18 February 2020 in Applied Physics Letters
Surface acoustic wave magnetic field sensors based on guided Love waves using the ΔE effect of a magnetostrictive thin film have been shown to be promising candidates for the measurement of weak fields at low frequencies as required for biomagnetic applications or as current sensors benefitting from the large dynamic range and bandwidth. The deposition of soft magnetic films with high magnetostriction is, however, more challenging on piezoelectric substrates such as quartz than on silicon. Thermally induced anisotropic expansion during the deposition process or during post-deposition magnetic field annealing leads to uniaxial stresses acting on the films, which makes the precise control of magnetic anisotropy difficult. Accordingly, this work analyzes the influence of the deposition process and heat treatment on the performance of Love wave devices. ST-cut quartz based delay line surface acoustic wave sensors with a SiO2 guiding layer are employed, and a 200 nm layer of amorphous magnetostrictive (Fe90Co10)78Si12B10 is used as the sensitive element. Magneto-optical imaging is performed for magnetic domain characterization, and the sensor performance is characterized in terms of bias field dependent phase sensitivity and frequency dependent phase noise. By performing a low temperature deposition in an external magnetic field, considerable improvement in limits of detection at biomagnetic relevant frequencies down to 70 at 10 Hz and 25 at 100 Hz is achieved.
1 August 2020 in Sensors and Actuators A: Physical
1 January 2021 in Food Control
16 July 2025 in Journal of Micromechanics and Microengineering
This paper presents progress towards the large-scale manufacturability of piezo- and ferroelectric Al1−x
Sc
x
N thin films with very high Sc content. Al0.6Sc0.4N layers were deposited by pulsed DC reactive sputtering from a 300 mm diameter Al0.6Sc0.4 target on standard 200 mm Si wafers with Pt bottom- and Mo top-electrodes. The deposited films were analyzed in depth with x-ray diffraction, reciprocal space mapping, scanning electron microscopy and energy dispersive x-ray spectroscopy showing well oriented c-axis growth over the full wafer with slight variation in the film thickness and Sc content over the wafer radius. An overall low density of abnormally oriented grains was found. Further wafer mapping for piezoelectric and dielectric properties showed a piezoelectric performance increase by 40% in comparison to Al0.7Sc0.3N while only moderately increasing the permittivity and loss factor. Switching measurements revealed ferroelectric behavior of the film on all measured positions with an average remanent polarization of 88.36 µC cm−2 and an average coercive field of 244 V µm−1. This successful demonstration opens new opportunities for MEMS applications with demands for high forces like microspeakers or quasi static micromirrors.
17 February 2025 in Applied Physics Letters
Single magnetic domain soft magnetic films are the basis for many magnetic field sensing applications. The absence of magnetic domain walls reduces magnetic noise, which is relevant for magnetic sensing layers and supporting structures such as magnetic shields and flux concentrators. Here, the use of wafer-level integrated NdFeB micromagnets for on-chip field biasing of soft magnetic submicrometer thick layers for magnetic domain control is presented. Effective bias field strengths are modeled and experimentally evaluated using a magnetooptical indicator film technique. Single magnetic domain behavior in the soft magnetic layers is demonstrated. Effects of the granular micromagnet structure on the magnetic field homogeneity are discussed. The demonstrated integrated magnetic biasing scheme is applicable to various magnetic layer-based field sensing devices benefiting from single magnetic domain behavior.
5 January 2025 in Surfaces and Interfaces
TMTatiana Lisboa Marcondes
+3