5 February 2018 in IEEE Access
In this paper, we consider the problem of power control and load balancing in the uplink of the cell-free (CF) multi-user (MU) massive multiple-input multiple-output system. The power control problem is solved using three different criteria: 1) power minimization; 2) maximize min quality of service (QoS); and 3) maximize sum spectral efficiency (SE) under imperfect channel state information. While power minimization and min-QoS maximization problems can be solved in polynomial time, sum SE maximization is NP-hard. Hence, we apply a successive approach to convert it into a geometric program and achieve near optimum solution. As the number of connections in CF-MU system is large, we minimize the number of base stations (BSs) serving each user while maintaining the optimized power consumption and QoS from the previous stage. We propose an iterative elimination (IE) algorithm to remove ineffective BSs for each user. The system analysis is performed under two common BS receivers: maximum ratio combining and zero forcing. The simulation shows that our method is better than both maximum signal-to-noise ratio association and full-set joint transmission, especially in the high QoS regime. Another notable result is that the selection of the linear receiver becomes more influential than the association method.
1 July 2020 in IEEE Access
Physical layer security (PLS) provides an additional protection layer to the conventional encryption in the presence of an active eavesdropper (Eve). The detection of pilot contamination attack (PCA) on legitimate nodes by the active Eve is vital in order to mitigate the effect of the attack. In this work, we propose a novel PCA detector for the nodes, which intend to establish secure communication in time division duplex (TDD) mode over a frequency selective channel. We devise binary hypothesis from the decision directed channel estimate for PCA detection by exploiting observations of pilot sequence and random data in pilot and data phases, respectively. We also provide performance analysis of the proposed method. The comparison of simulation results and analysis demonstrates the accuracy of the analysis. The proposed detector has low probability of detection error as compared to the existing high complexity sub-space based PCA detector.
1 January 2019 in IEEE Access
Hybrid automatic repeat request (HARQ) retransmission is an effective method to combat time-variant channel fading. Conventional HARQ methods initiate retransmission of failed packet without exploiting channel knowledge. When a packet fails, retransmission of data corresponding to high gain sub-carriers of an orthogonal frequency division multiplexing (OFDM) modulation is not necessary and deteriorates the throughput of the communication system. In this paper, we propose accumulated channel norm constrained selective retransmission (CNSR) at physical layer (PHY) in conjunction with HARQ method, which enhances throughput of the transceiver without compromising latency. When a packet fails, medium access control (MAC) layer requests retransmission of the failed packet. The proposed CNSR method initiates retransmission of data at PHY layer transmitted over low signal-to-noise ratio sub-carriers using outdated channel information. The transceiver pair continues retransmission of the failed packet until target channel norm of the sub-carriers is achieved or maximum number of retransmissions are completed. We maximize throughput by optimizing threshold on channel norm for OFDM modulation. We also present an upper bound on bit error rate and throughput analysis of the proposed method. The proposed method achieves higher throughput as compared with the existing Chase combining with selective repeat and conventional Chase combining schemes with and without forward error correction codes.
1 January 2026 in IEEE Microwave and Wireless Technology Letters
4 November 2025 in IEEE Transactions on Instrumentation and Measurement
Regular physiological monitoring of maternal and fetal parameters is indispensable for ensuring safe outcomes during pregnancy and parturition. Fetal electrocardiogram (fECG) assessment is crucial to detect fetal distress and developmental anomalies. Given challenges of prenatal care due to the lack of medical professionals and the limit of accessibility, especially in remote and resource-poor areas, we develop a fECG monitoring system using novel non-contact electrodes (NCE) to record the fetal/maternal ECG (f/mECG) signals through clothes, thereby improving the comfort during measurement. The system is designed to be incorporated inside a maternity belt with data acquisition, data transmission module as well as novel NCEs. Thorough characterizations were carried out to evaluate the novel NCE against traditional wet electrodes (i.e., Ag/AgCl electrodes), showing comparable performance. A successful preliminary pilot feasibility study conducted with pregnant women (n = 10) between 25 and 32 weeks of gestation demonstrates the system’s performance, usability and safety.