9 September 2024 in Measurement Science and Technology
The monitoring of micro-defects or external actions induced vacuum degradation in aerospace vacuum vessels is an important challenge. A vacuum-process monitoring method based on quasi-distributed fiber Bragg grating (FBG) sensing technology is proposed. Due to the influence of environmental noise and vacuum pump operation noise, the raw signals measured by FBG sensors contain a large amount of noises, which affects the measurement accuracy and data analysis. Therefore, the wavelet threshold (WT) denoising method is proposed to analyze the influence of noises on the monitoring signals measured by two different kinds of FBG sensors. The evaluation of the monitoring signals after denoising indicates that the proposed method can effectively remove the noise and significantly improve signal quality. The highest signal-to-noise ratio of the processed signals can reach 37.61 dB and the mean square error is 3.68 × 10−7, while retaining the key features of the original signal. The proposed WT denoising method demonstrates better performance and feasibility compared with moving average filtering and Kalman filtering methods. The study provides critical supports for improving the performance and reliability of the vacuum vessel monitoring system.
25 October 2024 in IEEE Sensors Journal
Pipes may have leakage, breakage and local blockage during the long-term service period, which may lead to insufficient flow velocity and low water-supply pressure. Therefore, measuring flow velocity in pipes is crucial for diagnosing damage, ensuring safe operation and managing maintenance. Current flow velocity measurement techniques exhibit poor stability over long-term measurements in complex environments and the measurement quality is affected by the physical and chemical properties of the transported medium. To address these issues, this study employs distributed optical fiber sensors for measuring flow velocity in water-filled pipes and the effectiveness is validated by the fiber Bragg grating (FBG) sensors. Based on the phase change of optical fiber demodulated by distributed acoustic sensing (DAS) device, the flow velocity is accurately measured. Test results demonstrate a quadratic relationship between flow velocity and phase change of optical fiber based on DAS system, with all fitting effects exceeding 0.95, consistent with theoretical analysis. The influence of different sensor layouts of the distributed optical fibers on the monitoring data is also carefully checked, and the testing results show that bonding the optical fiber on the pipes can achieve better measurement quality, compared to the free optical fiber without constraint around the pipe. This study contributes to improving the measurement accuracy and stability of optical fiber sensors by using the DAS system.
17 December 2025 in Measurement Science and Technology
Real-time monitoring of internal pressure changes of vacuum pressure vessels is particularly important in the aerospace industry, which can be adopted to instruct the fault analysis. Considering the poor measurement accuracy of traditional vacuum gauges, this paper provides the optical fiber-based sensing technology combined with the theoretical characterization of stress and strain distributions of vacuum vessels for reflecting the vacuum degree curves with high precision. The design and deployment of quasi-distributed fiber Bragg grating (FBG) sensors are then carried out to construct a real-time monitoring system. Statistical analysis is further performed to establish the modification coefficient to decrease the vibration effect on the testing signals during the vacuum extraction and unloading process, and wavelet denoising theory has also been adopted to further improve the accuracy of the experimental data, which shows higher accuracy of the monitoring parameter after the correction. The research results show that the integration of FBG sensing technology, statistical signal analysis, and processing algorithms can realize the real-time, sensitive, and high-precision monitoring of the vacuum degree curve, with the measurement accuracy enhanced by 50%, which can be used to replace traditional vacuum gauges. The study realizes real-time and accurate monitoring of the vacuum degree inside the pressure vessel based on the proposed FBG sensing technology and algorithms. It can be instructive for recognizing the fault state of the vacuum pressure and maintaining the stable and safe storage of energy resources.