31 October 2018 in IEEE Transactions on Microwave Theory and Techniques
17 December 2021 in IEEE Journal of Solid-State Circuits
In this work, we present a wireless energy-efficient fully integrated amplitude shift keying (ASK) transmitter (TX) array at 220 GHz. Each TX cell consists of an oscillator, a modulation switch, an on-chip antenna, and baseband amplifiers. The oscillator uses a harmonic generation technique that is optimized for maximum output power and efficiency. The ASK scheme is used for data modulation and is implemented with a fast switch that does not consume any dc power. Three of these TX cells are coherently coupled together to increase the signal-to-noise ratio (SNR) and, hence, the data rate. This also enables the possibility of having a four-level spatial ASK modulation. Fabricated in a 55-nm SiGe bipolar complementary metal oxide semiconductor (BiCMOS) process, the array dissipates 165.2 mW of dc power and generates 4.2-dBm effective isotropic radiated power (EIRP). The chip demonstrates a 20-Gb/s data transmission rate with on-off keying (OOK) modulation at a 28-cm distance using low-cost Teflon lenses. The measured energy efficiency of the array is 8.26 pJ/bit. To the best of our knowledge, this work demonstrates the best energy efficiency among TX arrays at this frequency range.
20 April 2020 in Applied Physics Reviews
We review the recent advances on the implementation of electronic circuits that operate in the millimeter-wave (30–300 GHz) and terahertz (300–3000 GHz) frequency ranges. The focus of this article is on nonlinear phenomena in electronics. The different implementations of nonlinear circuits for the sake of millimeter-wave and terahertz signal generation are studied in this paper. The challenges of signal generation are examined and the benefits and limitations of different schemes of signal generation are discussed. It is shown that nonlinear devices such as electronic transistors exhibit major advantages enabling realization of low-cost and portable circuits for the emerging applications in these frequency ranges. We also review linear and nonlinear design methodologies employing the properties of electromagnetic waves. The electronic systems designed based on the presented ideas are shown to push the previously unbeatable limits of operation in millimeter-wave and terahertz frequency ranges. A discussion on remaining challenges and future directions concludes the paper.
4 November 2022 in Translational Oncology
• Terahertz (THz) technology can be employed as a non-invasive imaging for early detection and cancer diagnosis. • THz medical imaging detect changes in water content and structural variations to distinguish cancerous cells from normal tissues. • Nanoparticle contrast agents may enhance sensitivity and specificity of THz imaging.
23 August 2019 in IEEE Solid-State Circuits Magazine
Terahertz (THz) radiation ranging from 300 GHz to 10 THz [1] has attracted a growing number of researchers over the past decade. They are enthusiastic about its great potential for biomedical diagnoses, security screening, and highspeed communication. For instance, a THz wave can propagate through dry, nonmetallic, and nonpolar materials with small attenuation. This ability, combined with its small wavelength (versus microwave) and photon energy (versus X-ray), makes a THz wave an ideal option for nonionizing medicalimaging, such as a burn injury assessment [2] or skin cancer diagnosis [3]. A short-range wireless link operating at such an unallocated band is also expected to significantly boost transmission speeds. In [4], a 25-Gb/s link with a 220-GHz carrier was demonstrated over a distance of 50 cm. A higher data rate of 100 Gb/s is anticipated in the near future [5].