Mark Flores

Mark Flores

Auto-generated profile, based on publicly available information

Mark Flores

Air Force Research Laboratory, Wright-Patterson AFB, OH 45433, USA

Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
11 April 2024 in Journal of Multiscale Modelling
Verified
Journal Article
Closed access
SAShah Alam
Shah Alam
GGGuodong Guo
Guodong Guo
MFMark Flores
Mark Flores
VVVikas Varshney
Vikas Varshney

26 March 2022 in Journal of Reinforced Plastics and Composites
Verified
Journal Article
Open access
LXLuoyu R Xu
Luoyu R Xu
MIMd Shariful Islam
Md Shariful Islam
RMRicardo Martinez
Ricardo Martinez
MFMark Flores
Mark Flores
Kai ZhaoKai Zhao
Kai Zhao
Ertugrul TacirogluErtugrul Taciroglu
Ertugrul Taciroglu
Nanoindentation (nanometer scale, extremely small) and impact (microsecond scale, extremely fast) experiments are two important techniques for characterizing modern material systems. However, these two experiments were often studied individually. In this pilot study, a multiscale indentation mechanics approach is proposed to correlate these two very different mechanics events acting on the same target materials using a spherical indenter and a projectile. The contact stiffness of nanoindentation of a target material is fitted using Hertz’s contact law, and then the contact stiffness of impact is obtained using a simplified multiscale relation. Therefore, the maximum impact force of a projectile impact can be predicted by inputting the impact energy and the contact stiffness of impact. The above new approach was validated by drop-weight impact experiments of polymers and structural composite materials subjected to low-energy impact. Results show that only a few minutes are needed to predict the maximum impact force.

20 September 2021
Verified
Conference Paper
Closed access
PDF file
LGLuke Geise
Luke Geise
AAAndrew Abbott
Andrew Abbott
DRDaniel Rapking
Daniel Rapking
MFMark Flores
Mark Flores
Additive manufacturing (AM) of short-fiber reinforced composites are actively being considered for construction of low-cost, weight reducing alternatives to non-structural metal components. In addition AM parts are being used for rapid manufacturing of composite tooling. AM is notorious for generating parts with higher porosity than more traditional manufacturing technologies. Due to the aerospace industry’s low risk tolerance, novel material systems require comprehensive characterization of their associated manufacturing defects and the impact of defects on performance in order to receive certification. AM short fiber composites still require this analysis. Although traditional composite manufacturing methods, such as an autoclave or VARTM can produce porosity, the origin and transport of porosity has been thoroughly studied and acceptable limits for part qualification have been established to minimize the effect on performance. In AM components studies establishing the origination of porosity origin and processing defect related minimization strategies are lacking. A preliminary study on the impacts of porosity caused by print parameters such print speed, layer height, first layer height, and step-over distance has been undertaken. Direct Ink Writing (DIW) was selected for this study using an epoxy-based ink filled with clay and chopped carbon fiber. To understand performance, fracture and shear specimens were fabricated with different test parameters based on the assumed levels of porosity from screening tests. Samples were then mechanically tested using a novel in-plane shear test method and a single edge notch tension test. This study explores the processing parameter’s contribution to porosity and establishes general trends to understand the influence of porosity on performance for additively manufactured chopped fiber composites.