20 December 2023 in IEEE Transactions on Applied Superconductivity
Fe-based nanocrystalline materials is a typical soft-magnetic material with advantages such as high saturated magnetic flux, high resistivity and low magnetostriction coefficient. By utilizing a specialized winding process, the ultra-thin strip has been successfully applied for use in scanning magnetic cores. For static field, the simulated and tested integral magnetic field uniformity is consistent, and tested effective length is slightly shorter than simulated one. The static magnetic field can meet the needs of scanning magnets. For transient field, the new iron core has less magnetic field delay and distortion compared to silicon steel sheet iron. The simulated maximum magnetic field delay is reduced from 161 Gauss to 16 Gauss. The maximum magnetic field delay of silicon steel sheet iron under test is 87 Gauss, and the corresponding data of the new iron core is almost 0 Gauss. With the weakening of the magnetic field delay, the magnetic field distortion should also be suppressed. With the novel iron core, the magnetic field of the scanning magnet can be improved, thereby reducing the distance from the scanning magnet to the terminal. Rotating gantry is the focus of current research on proton and heavy ion therapy accelerator facilities. This novel iron core can facilitate a decrease in the rotating diameter and weight of the gantry, while enhancing the scanning accuracy. Moreover, the novel iron core can be exploited in scenarios where ferrite cores are “excess capacity”, but traditional silicon steel cores are “insufficient capacity”, such as for certain bump magnets used in synchrotrons.
23 February 2024 in IEEE Transactions on Applied Superconductivity
The Space Environment Simulation and Research Infrastructure (SESRI), located at the Harbin Institute of Technology (HIT) in China, is a new infrastructure project proposed by the Institute of Modern Physics, Chinese Academy of Sciences (IMP, CAS), and completed in 2022. As a critical part of SESRI, the compact synchrotron was designed with a circumference of less than 44 m and compact magnets. In order to achieve compact injection and improve injection efficiency, four fast-ramping bump magnets based on ferrite yokes were used. All four bump magnets have a fast falling time from 20–100 µs, a maximum magnetic field of 0.0797 T, and a gap of 60 mm. To reduce the magnetic eddy current effect and coil inductance during fast excitation, ferrite core structures with single copper bar saddle windings are used. Further, window-frame structures are used to facilitate the ferrite-core machining process. After the prototype bump magnet was fabricated and the pulsed magnetic field measured, it was found that the integrated magnetic field curve did not align with the output current curve of the power supply. This was found to be caused by eddy currents from the copper gaskets between ferrite cores. Through the simulation and secondary testing of the gasket-induced eddy currents using different materials, the eddy current has been significantly reduced. In this study, the magnetic field optimization, structural design, eddy current calculation, and magnetic field measurement of the fast-ramping bump magnets are analyzed.