1 July 2021 in IEEE Transactions on Components, Packaging and Manufacturing Technology
Reliability results obtained on a photosensitive polymer-based RDL process with two-metal layers and a target pitch below 4 μm are presented. Fully processed samples have been subjected to 1000 hours of high temperature storage performed at 150 °C when a second set of samples endured a temperature-humidity stress executed at 85 °C and 85 %RH. A thermal cycling stress between -50 °C and 125 °C for 1000 cycles was also performed on a third sample set. After 1000 hours spent at 150 °C, an increase in the metal line resistivity resulting from copper oxidation by atmospheric oxygen diffusing through the polymer is observed. The oxidation of the top part of the metal lines is further confirmed by failure analyses performed on the stressed samples. Eight different polymers used as a potential capping solution to block the diffusion of oxygen toward the metal lines are investigated. The most promising approach for a reliable polymer-based RDL process involves the use of a mold layer.
1 January 2017 in Journal of Smart Processing
Photodefinable wafer-level underfill (PWLUF) has been developed to avoid the underfill entrapment which causes mechanical and electrical reliability issues with fine bumps. In this paper, firstly, we report the appropriate stacking profile to obtain voidfree stacks, explaining the PWLUF process flow and the melt viscosity after patterning. Secondly, the lower pressure soldering on thermal compression and collective reflow soldering without any underfill entrapment were demonstrated. It means that this PWLUF was designed to have enough low viscosity after photo-curing for patterning. The stacked sample has enough high adhesive strength even after moisture absorption and passed moisture sensitivity level 2 (JEDEC MSL2). Finally, we demonstrated the compatibility with Cu-Cu bonding application comparing with conventional no-flow type underfills (NUF).