Shifan Dong

Shifan Dong

Auto-generated profile, based on publicly available information

Shifan Dong

Department of Electrical Engineering, Beijing Jiaotong University, Beijing, China

Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
15 June 2022 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
SDShifan Dong
Shifan Dong
MZMinglei Zhou
Minglei Zhou
XYXiaojie You
Xiaojie You
CWChenchen Wang
Chenchen Wang
This article presents a sensorless control strategy by injecting high-frequency (HF) voltage into the d -axis for the interior permanent magnet synchronous motor (IPMSM) in the full speed range. The defined quadratic virtual back electromotive force model can be adopted in the full speed range, and thus, there is no need to design a transition algorithm from the zero–low speed to the medium–high speed. Besides, the accurate model of IPMSM is applied to eliminate the error caused by ignoring the stator resistance. Furthermore, the estimation error caused by the filter and system delay during demodulating the HF current in the conventional HF voltage injection method is avoided. Compared with the method of injecting HF voltage into the q -axis, the proposed method has smaller torque ripple and smaller injected voltage. The effectiveness of the proposed method is verified by experimental results.

6 November 2023 in IEEE Transactions on Transportation Electrification
Verified
Journal Article
Closed access
SDShifan Dong
Shifan Dong
MZMinglei Zhou
Minglei Zhou
CWChenchen Wang
Chenchen Wang
XYXiaojie You
Xiaojie You
High-frequency (HF) voltage injection methods are usually used in sensorless control for interior permanent magnet synchronous motor (IPMSM) at low-speed. The stator resistance is ignored when the frequency of HF voltage is high enough. However, in high power application, the frequency of injected voltage becomes low limited to low switching frequency, which leads to rotor position estimation error due to ignoring stator resistance. Moreover, the phase delays caused by the filter and large system delay under low switching frequency bring estimation error, which changes with speed and cannot be directly compensated. Therefore, this paper proposes a sensorless control by injecting HF voltage at one-third of switching frequency. To reduce the influence of stator resistance on estimated result, the HF current generated by the 5th harmonic of injected HF voltage is adopted to estimate rotor position, which increases the equivalent frequency of HF signal. To eliminate the estimation error caused by filter and system delay, an adaptive compensation strategy for total disturbance is applied. Besides, the voltage and generated current at injection frequency are adopted to identify the stator inductance by recursive least squares, which improves the performance of torque control. The proposed methods are verified by simulation and experimental.

5 July 2024 in IEEE Transactions on Energy Conversion
Verified
Journal Article
Closed access
SDShifan Dong
Shifan Dong
MZMinglei Zhou
Minglei Zhou
CWChenchen Wang
Chenchen Wang
LGLifeng Gou
Lifeng Gou
XYXiaojie You
Xiaojie You
This paper proposes an improved hybrid sensorless control method for interior permanent magnet synchronous motor (IPMSM) in full speed range at low switching frequency. At low speed, the conventional high-frequency (HF) voltage injection method is difficult to implement at low switching frequency because of the special dual sampling rate mechanism. Therefore, this paper proposes an improved square wave voltage injection method, which separates the observation of rotor position from the injection of HF voltage and the extraction of HF current based on dual sampling rate mechanism. Then, the error caused by large PWM delay at low switching frequency is analyzed and compensated. At high speed, to avoid the influence of cross coupling due to discretization error on the estimated rotor position at low switching frequency, the cross coupling caused by modeling in continuous time domain is analyzed, then a state observer is established in discrete time domain directly. A 3 kW experimental platform is built to verify the effectiveness of proposed method.

17 October 2026 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
Guoqiang ZhangGuoqiang Zhang
Guoqiang Zhang
KYKai Yang
Kai Yang
QWQiwei Wang
Qiwei Wang
YYYunhao Yan
Yunhao Yan
KWKairan Wang
Kairan Wang
DXDianguo Xu
Dianguo Xu