This letter proposes an ultralow power single-inductor multiple-output converter for an implantable stimulation system. This converter minimizes the number of switches turning on and off to deliver power to outputs of 0.8, 1.8, and 20 V, and it uses a soft-switching technique for all switching nodes. It also operates with a self-oscillating controller only when outputs require power. As a result, it has a peak efficiency of 92.3% when the converter generates the outputs of 0.8 and 1.8 V, of which load currents are 2 and 0.5 mA, respectively, from a battery voltage of 3 V. The converter consumes a quiescent power of less than 3.0 μ W.
In portable mobile devices, the capacitor-less low-dropout regulator (LDO) is in great demand as a power management unit to achieve complete on-chip design [1] –[6]. In the capacitor-less LDO, it is important to achieve two things: good load/line regulations and a fast transient response.
25 September 2023 in IEEE Journal of Solid-State Circuits
This article presents a single-inductor bipolar-output (SIBO) converter for active-matrix organic light-emitting diode (AMOLED) displays to reduce output ripples and enhance power conversion efficiency (PCE). We propose the simultaneous energy transferring SIBO (SETSIBO) converter, which generates bipolar outputs with only a two-phase operation and does not require additional switching. The hybrid power stage with a flying capacitor and two-phase operation reduces the dc value of the inductor current, which mitigates conduction losses and output ripples; moreover, the hybrid power stage allows the high-voltage switches in the conventional converters to be replaced by low-voltage switches. The inductor current reduction and the low-voltage power switch use improve the PCE. This article analyzes the proposed converter’s output ripple reduction and the PCE improvements; furthermore, the load imbalance is effectively compensated with the proposed SETSIBO converter. The prototype of the proposed SETSIBO is fabricated in a 0.5- $\mu \text{m}$ CMOS process. The measured ripples at positive and negative outputs are 24.5 and 28 mV, respectively, with a 300 mA load current $I_{\mathrm {o}}$ . The measured peak PCE is 94.1%, and the active area is 1.46 mm2.
1 August 2025 in IEEE Solid-State Circuits Letters
This paper presents an off-chip output capacitor (CO)-scalable (OCS) boost converter. The proposed OCS boost converter is possible to operate both with and without the off-chip CO. In addition, it operates in a whole conversion ratio (CR) range over 1 while maintaining a small current ripple of an inductor, resulting in a high efficiency with an inductor of which inductance is small, irrespective of the CO capacitance. The converter was fabricated in 130-nm BCD process and shows a peak efficiency of 96.68% at VIN = 5.5 V, VO = 7 V and IO=200mA which has the CR of 1.27.