Hui Liu

Hui Liu

Auto-generated profile, based on publicly available information

Hui Liu

School of Electrical and Electronics Engineering, Huazhong University of Science and Technology, Wuhan, China

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
27 March 2018 in Advances in Mechanical Engineering
Verified
Journal Article
Open access
BJBoyan Jiang
Boyan Jiang
HLHui Liu
Hui Liu
BLBin Li
Bin Li
JWJun Wang
Jun Wang
The flow pattern in the volute of a squirrel cage fan is complicated and non-axisymmetric. In this article, the original volute profile of a squirrel cage fan was cut to control and reshape this non-axisymmetric flow structure. An experimental study was conducted to investigate the effects of the cut volute profile on the fan aerodynamic and acoustic performance. The results showed that cutting the volute profile with a relative cut position of 90° and a secondary clearance of 0.02 D2 could enhance the fan total pressure at the volume flow rate of 0.4 QBEP by about 7% without affecting the noise level. High-precision steady computational fluid dynamics simulation was also carried out to reveal the flow mechanism of the performance improvement. The results indicated that cut volute profile caused an impeller-across flow structure in the vicinity of the second clearance and re-organized the circumference distribution of the impeller flow status. Both the impeller working capability and the overall flow losses of the cut fan increased compared to the original one but the increment of the former was greater. This explains why fan pressure improved under low-flow conditions.

8 October 2024 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
YXYuanhao Xie
Yuanhao Xie
Dong JiangDong Jiang
Dong Jiang
HLHui Liu
Hui Liu
Zicheng LiuZicheng Liu
Zicheng Liu
The active magnetic bearing (AMB) driven by power electronic converters is an emerging technique in the industry to suspend high-speed rotating machinery. The high-frequency switching of the converter can bring electromagnetic interference (EMI) to the system, affecting its reliable operation. This article focuses on the modeling of common mode (CM) EMI in multiaxis AMB systems. The impedance characteristics should be measured online due to the variation of rotor position. Thus, the multiaxis online impedance measurement scheme has been proposed in this article. The impedance measurement requires consideration of both signal-to-noise ratio and independence of different excitation tests. The CM equivalent circuit model has also been built and the parameters have been extracted with a two-step fitting scheme. The experiment has been done to prove the effectiveness of the proposed model. With the proposed method, the CM EMI of multiaxis AMB can be precisely predicted. Furthermore, the CM EMI filter has been designed for the AMB based on the proposed model.

29 July 2024 in IEEE Transactions on Industrial Electronics
Verified
Journal Article
Closed access
HLHui Liu
Hui Liu
Dong JiangDong Jiang
Dong Jiang
SZShuyu Zhang
Shuyu Zhang
XZXuan Zhao
Xuan Zhao
Zicheng LiuZicheng Liu
Zicheng Liu
This article analyzes the common-mode voltage (CMV) of the Vienna rectifier and proposes a CMV elimination strategy. The proposed method reduces the neutral-point voltage (NPV) fluctuation by introducing an auxiliary flying capacitor (FC) leg and suppresses low-frequency fluctuations of CMV through zero CMV (ZCMV) modulation. Aimed at the high-frequency spikes of CMV, an analysis of nonideal factors, including unidirectional conduction of the diode, current distortion, and current ripple and control delay is conducted leading to the proposal of a novel compensation method called FC-ZCMV-C. Experimental results indicate that, without affecting the power factor of the rectifier, FC-ZCMV-C further suppresses the CMV spikes, significantly reducing common-mode electromagnetic interference by 10–20 dB.

30 April 2025 in IEEE Transactions on Industrial Electronics
Verified
Journal Article
Closed access
HLHui Liu
Hui Liu
JGJiwen Gong
Jiwen Gong
Dong JiangDong Jiang
Dong Jiang
YMYafei Ma
Yafei Ma
Zicheng LiuZicheng Liu
Zicheng Liu
The article analyzes the common-mode (CM) electromagnetic interference (EMI) in four three-phase two-level inverter parallel (FTTIP) system and proposes a novel zero-CM voltage (ZCMV) modulation strategy by equivalently treating each phase as a five-level system. It also analyzes the impact of dead zone, using ZCMV with dead zone compensation and random variable dead zone (ZCMVCR) to further enhance the ultimate capability of active EMI suppression. It also maintains output voltage balance to improve overall system performance. Simulation and experimental verification are conducted. The experimental results show that compared to traditional space vector pulse width modulation (SVPWM), ZCMVCR can reduce CM EMI by 10–25 dB in the range of 10 kHz–3 MHz. The variable dead-zone method can further reduce the CM EMI by 5–10 dB in high frequency range of 1–3 MHz on the basis regular ZCMV.

10 November 2023
Verified
Conference Paper
Closed access
HLHui Liu
Hui Liu
Dong JiangDong Jiang
Dong Jiang
SZShuyu Zhang
Shuyu Zhang
XZXuan Zhao
Xuan Zhao
JCJianan Chen
Jianan Chen
The utilization of constant switching frequency pulse width modulation (CSFPWM) in the Vienna rectifier leads to the generation of numerous electromagnetic interference (EMI) spikes within its frequency spectrum. A sinusoidal spread spectrum modulation method is presented in this paper. When the maximum amplitude of three-phase current increases, the switching frequency decreases. On the basis of reducing EMI, the efficiency of the system is improved by reducing the switching loss. The experimental results show that compared with CSFPWM, sinusoidal PWM (SINPWM) can reduce the conducted EMI by 15dB.

28 May 2025 in IEEE Transactions on Industrial Electronics
Verified
Journal Article
Closed access
JZJunzhao Zhang
Junzhao Zhang
JLJianrui Liu
Jianrui Liu
HLHui Liu
Hui Liu
Dong JiangDong Jiang
Dong Jiang
YZYechi Zhang
Yechi Zhang
HLHongyang Liu
Hongyang Liu
Active electromagnetic interference (EMI) filters (AEFs) are effective alternatives to passive EMI filters for increasing the power density of switched-mode power converters. This article presents a grounding impedance-based active common-mode (CM) EMI filter (GI-AEF). Unlike conventional filters placed in the primary circuit, the GI-AEF is installed in the grounding loop to suppress CM EMI without bulky transformers. It only handles low-CM currents and avoids needing high gain-bandwidth operational amplifiers, resulting in a compact and cost-effective design. Additionally, the GI-AEF ensures low-grounding voltage even during power failures, enhancing safety. Experimental results show that it reduces filter volume and weight by over 50% while cutting costs by 34%—marking the first instance of cost reduction in the academic literature through AEF technology.