A concept for the development of spectrum-clean S1 Lamb wave resonator (LWR) utilizing an aluminum nitride (AlN) plate with damped edge reflectors is demonstrated. Numerical analysis is performed on the dispersive characteristics of the Lamb modes propagating in AlN plates, and the design parameters to enable zero group velocity (vg) for the S1 mode are identified. The simulation results based on finite element analysis verify that the use of the damped edge reflectors, instead of the conventional edge reflectors, can efficiently de-couple most of the Lamb waves such as the S0 mode by mode conversion upon edges, but not the S1 mode characterizing zero vg. Specifically, the measured frequency response of a 1.38-GHz AlN S1 LWR with damped edge reflectors yields a clean spectrum up to 6 GHz and excellent resonance passband performance.
A -108dBm sensitivity, 430MHz, 130nW-41µW, 6.25bps-4.2kbps, digitally tunable wake-up and data receiver in 65nm CMOS is presented. Employing 2-tone RF OOK modulation and an AlN MEMS resonator, the receiver attains close-in SIR of -25dB at 0.12% and far-out SIR of -28dB at 0.7% frequency offset from the carrier. Digitally configurable dynamic ranges of 11dB, 410X, 672X are achieved for sensitivity, power, and latency, respectively. The design receives data at a 4.2kbps bit-rate at - 108dBm sensitivity while consuming 41µW. The proposed WuRx is a highly reconfigurable and interference robust candidate for emerging ultra-long range IoT LPWAN applications.
This paper presents a 3.5 GHz aluminum nitride (AlN) microelectromechanical system (MEMS) resonator. The high frequency resonance is attained by exploiting the high phase velocity S1 Lamb mode in an AlN thin film. Finite element analyses (FEA) are employed to show a high phase velocity larger than 50000 m/s and a large electromechanical coupling of 3.6% for S1 when h AlN =0.1λ. As predicted by the simulation, the fabricated resonator demonstrates a high frequency resonance at 3.5 GHz and a large electromechanical coupling (k t2 ) of 3.59%. Among the demonstrated S1 mode deviecs, this work has achieved the highest product of merit, f · k t2 · Q, of 69.1.
1 January 2012 in Progress In Electromagnetics Research