This article presents a highly integrated 2.4-GHz wake-up receiver (WuRX) achieving 91.5 dBm sensitivity with a state-of-the-art power and latency combination of 2 $\mu \text{W}$ at 100 ms. The proposed within-packet duty-cycling method employs a carrier-sense mechanism to turn off the WuRX early under idle channel conditions, which reduces the dc-power compared with conventional asynchronous packet-level duty cycling by $9\times $ at 10 ms latency (21 $\mu \text{W}$ ) and $2\times $ at 1 s latency (0.9 $\mu \text{W}$ ) at the cost of 2 dB in sensitivity. The uncertain-IF topology with a phase-locked loop (PLL)-aided event-driven calibrated local-oscillator (LO) helps reduce the dc-power while maintaining a fast startup. The channel-embedded OOK scheme is used to create a deterministic IF to enable baseband (BB) channel selection and achieve continuous wave (CW) interference tolerance of −47 dB at 20 MHz offset. Fabricated in 65 nm CMOS, input matching and $LC$ oscillator are all implemented on-chip, and operation is demonstrated with integrated low dropout regulators to capture the degradations in realistic system integration.
12 February 2021 in IEEE Journal of Solid-State Circuits
In this article, we present the design and analysis of a 785-nW multimodal sensor interface IC for ozone pollutant sensing and correlated cardiovascular disease monitoring based on electrocardiography (ECG) and photoplethysmography (PPG). The proposed hybrid dc offset current cancellation (DCOC) along with a 4- MΩ gain-regulated cascode transimpedance amplifier (RGC-TIA) enable PPG readout power reduction by 37×, compared with the state-of-the-art PPG sensor interfaces. The ozone sensing channel proposes an adaptive architecture to enable low V DD operation, achieving a 300× power reduction, compared with the state-of-the-art gas sensing readouts. The ozone sensing channel's performance was also verified using custom resistive metal-oxide sensors for concentrations from 50 to 900 ppb. The sensor interface IC is fabricated in a 65-nm CMOS, integrating a 165-nW voltage-mode ECG channel, a 532-nW current-mode PPG channel, 76-nW resistive-mode ozone channel, and 12.6-nW peripheral circuits, all at 0.6 V. The total system power consumption including the LED and a custom digital readout IC is 10.98- 15.51 μW, which is 41×- 57× less than prior ozone/CVD joint monitoring sensor interface systems.
23 November 2021 in IEEE Transactions on Microwave Theory and Techniques
This article presents a highly integrated, supply, temperature, and interference-robust, event-driven wake-up receiver (WuRx) achieving $< -78.3$ -dBm sensitivity using a custom-designed antenna at 4.9 GHz or $< -72.3$ -dBm sensitivity when matched to a 50- $\Omega $ source at 5.3 GHz, consuming 184 nW at room temperature. The chip is fabricated in 65-nm CMOS LP technology and powered by a single supply. A novel slot antenna is proposed to directly conjugate match to the input of the chip and eliminate lossy impedance matching networks. The integrated references and regulation enable the receiver to operate for a wide range of temperatures from $-30\,\,^\circ \text{C}$ to 70 $^\circ \text{C}$ and a supply range from 1.2 to 1.5 V. The integrated proportional–integral–derivative (PID) control module allows the WuRx to automatically adapt for different temperatures and interference signals present in the ambient environment.
A -108dBm sensitivity, 430MHz, 130nW-41µW, 6.25bps-4.2kbps, digitally tunable wake-up and data receiver in 65nm CMOS is presented. Employing 2-tone RF OOK modulation and an AlN MEMS resonator, the receiver attains close-in SIR of -25dB at 0.12% and far-out SIR of -28dB at 0.7% frequency offset from the carrier. Digitally configurable dynamic ranges of 11dB, 410X, 672X are achieved for sensitivity, power, and latency, respectively. The design receives data at a 4.2kbps bit-rate at - 108dBm sensitivity while consuming 41µW. The proposed WuRx is a highly reconfigurable and interference robust candidate for emerging ultra-long range IoT LPWAN applications.
10 April 2024 in IEEE Open Journal of the Solid-State Circuits Society
This paper presents a binary frequency-shift keying (BFSK) heterodyne wake-up receiver (WuRx) with -102 dBm sensitivity at 2.4 GHz. An integrated low-power all-digital phase-locked loop (ADPLL) allows sharp filtering at the intermediate frequency (IF) to improve sensitivity and interference robustness. The WuRx achieves an average current consumption of 2.2 μA to 171 μA range at 16 s to 0.1 s latency with the packet-level-duty-cycling scheme. In addition, it supports up to 60 channels from 2.300 GHz to 2.536 GHz. A signal-to-interference ratio (SIR) of -27/-30/-46 dB is achieved at 3/5/25 MHz offset from the carrier.