Laser-driven proton acceleration, as obtained by the interaction of a high-intensity laser with matter, is a promising technique for generating high-quality proton beams. One of the main challenges is increasing the maximum proton energy. Here, we demonstrate a 70% increase in the maximum energy of laser-driven protons by optimizing the wavefront of the intense laser using machine learning: This was accomplished through adaptive control of a deformable mirror (DM) using a multi-step Random Forest surrogate-assisted Bayesian optimization approach. Starting from zeroed DM actuator voltages, our method identified an optimal configuration using 20 out of 48 actuators, requiring fewer than 150 experimental data samples. Our method surpassed conventional wavefront correction by 24%, which typically minimizes aberrations to converge toward a flat wavefront by leveraging real-time feedback from a wavefront sensor. This data-driven method integrating advanced wavefront control challenges the preference for correcting aberrations to achieve a flatter wavefront in laser-driven ion acceleration. We also propose a strategy for optimizing short focal length ion accelerators at facilities where measuring the wavefront at nominal full laser power is not implemented.
High-sensitivity material analysis techniques, relying on conventional (radio frequency-based and electrostatic) particle accelerators, such as particle-induced x-ray emission and particle-induced gamma-ray emission, face limitations for widespread applications due to their size and complexity, restricting real-time and portable use. In this Letter, we demonstrate that the simultaneous use of laser-generated protons and laser-generated x-rays, as obtained by interaction of a high-power laser with a target, can be used to analyze aerosols and emission gases and allow for a rapid detection of (harmful) elements down to particle concentrations of hundreds of ppm. This technique represents a promising advancement for portable, rapid, and real-time chemical composition analysis with potential applications in environmental monitoring, industrial emissions, and urban air quality management.
Ultrafast x-ray pulses from laser–plasma interactions have the potential to diagnose inertial confinement fusion and other high energy density environments with high spatial and temporal resolution. We discuss a new application for laser wakefield acceleration betatron x-rays: computed tomography (CT) of inertial confinement fusion fuel capsules. Here, we use betatron x-rays of source size 1.8±1.5 μm and a broadband spectrum with a critical energy of 19±4 keV, subject to on-shot fluctuations. Absorption radiographs of a capsule were taken from 360 angles in 1° increments and reconstructed into a CT image volume.