Department of Precision Instrument, National Key Laboratory of Space-Time Information Precision Sensing Technology, Tsinghua University, Beijing, China
Auto-generated profile, based on publicly available information
Lijun Wang
Department of Precision Instrument, National Key Laboratory of Space-Time Information Precision Sensing Technology, Tsinghua University, Beijing, China
This review is focused on the latest developments in continuous-wave (CW) photomixing for Terahertz (THz) generation. The first part of the paper explains the limiting factors for operation at high frequencies ∼ 1 THz, namely transit time or lifetime roll-off, antenna (R)-device (C) RC roll-off, current screening and blocking, and heat dissipation. We will present various realizations of both photoconductive and p-i-n diode–based photomixers to overcome these limitations, including perspectives on novel materials for high-power photomixers operating at telecom wavelengths (1550 nm). In addition to the classical approach of feeding current originating from a small semiconductor photomixer device to an antenna (antenna-based emitter, AE), an antennaless approach in which the active area itself radiates (large area emitter, LAE) is discussed in detail. Although we focus on CW photomixing, we briefly discuss recent results for LAEs under pulsed conditions. Record power levels of 1.5 mW average power and conversion efficiencies as high as 2 × 10−3 have been reached, about 2 orders of magnitude higher than those obtained with CW antenna-based emitters. The second part of the paper is devoted to applications for CW photomixers. We begin with a discussion of the development of novel THz optics. Special attention is paid to experiments exploiting the long coherence length of CW photomixers for coherent emission and detection of THz arrays. The long coherence length comes with an unprecedented narrow linewidth. This is of particular interest for spectroscopic applications, the field in which THz research has perhaps the highest impact. We point out that CW spectroscopy systems may potentially be more compact, cheaper, and more accurate than conventional pulsed systems. These features are attributed to telecom-wavelength compatibility, to excellent frequency resolution, and to their huge spectral density. The paper concludes with prototype experiments of THz wireless LAN applications. For future telecommunication systems, the limited bandwidth of photodiodes is inadequate for further upshifting carrier frequencies. This, however, will soon be required for increased data throughput. The implementation of telecom-wavelength compatible photomixing diodes for down-conversion of an optical carrier signal to a (sub-)THz RF signal will be required.
The accuracy of atomic isotope shift factors limits the extraction of nuclear charge radii from isotope shift measurements because determining these factors is experimentally and theoretically challenging. Here, the isotope shift of the transition is measured precisely using laser-induced fluorescence from a sympathetically cooled large ion crystal. A King-plot analysis is performed based on the new measurement to obtain accurate atomic field shift and mass shift factors that have been cross-checked by state-of-the-art configuration interaction plus many-body perturbation theory. The nuclear charge radii () of extracted using these and values demonstrate a near fivefold precision increase in the neutron-rich region. This work proves that accurate extraction of from isotope shifts is possible. New values reveal hidden discrepancies with previous density functional predictions in the neutron-rich region and pose strong challenges to advancements in nuclear models.
13 October 2022 in IEEE Transactions on Instrumentation and Measurement
Aiming at the adverse effects of fiber dispersion over long-distance frequency dissemination, a dispersion correction scheme based on chirped fiber Bragg grating (CFBG) is proposed. The dispersion correction effect is studied and a frequency dissemination experiment is carried out on a 310 km urban fiber link from Tsinghua University to Zhangjiakou city with $2.2\times 10^{-{1}4}$ /s and $2.6\times 10^{-{17}}/10^{{5}}$ s stabilities achieved. Through implementing distributed dispersion correction and asymmetrical optical amplification at each optical amplification node in the fiber link, the dissemination distance is extended to 500 km by connecting 50 km-100 km-150 km-100 km-100 km fiber spools. The great challenge caused by the section of 150 km fiber spool has been overcome and frequency dissemination stabilities of $1.7\times 10^{-{14}}$ /s and $6.7\times 10^{-{18}}/10^{{5}}$ s are obtained, which reveals the potential and applicability of the dispersion correction-based frequency dissemination system.
1 August 2023 in IEEE Transactions on Instrumentation and Measurement
Over the past few decades, fiber-optic time synchronization (FOTS) has provided fundamental support for the efficient operation of modern society. Due to the finiteness of the speed of light, calculating the fiber link delay is a key step in the traditional FOTS methods to achieve time synchronization. In this paper, a time reversal enabled FOTS method is proposed. Enabled by time reversal, a new idea for FOTS is demonstrated: the clock difference between two sites can be measured without calculating the fiber link delay. Therefore, the data layer is no longer needed to exchange the timing information between two sites. It can also achieve multiple-access time synchronization along the fiber link. Time synchronization performance characterized by time deviation (TDEV) of 25 ps at 1 s and 2 ps at 1000 s on a 230 km fiber link are obtained, and the function of multiple access is demonstrated.
25 January 2021 in IEEE Transactions on Instrumentation and Measurement
Classical absolute gravimeters are widely used in many areas, including metrology, seismology, geophysics, and exploration. These gravimeters apply a free-fall method to measure absolute gravitational acceleration using a laser interferometer. In practice, the measurement precision is affected by ground vibrations. Vibration correction is an important way to deal with these ground vibrations for absolute gravity measurement. Most vibration correction methods use a commercial seismometer to measure the motion of a reference retroreflector indirectly. A vertical seismometer with a built-in retroreflector is designed to directly measure the motion of the retroreflector, which is fixed on the proof mass of the seismometer. The motion of the retroreflector relative to the ground vibration is measured through capacitance detection. A voice coil actuator is employed to drive the retroreflector to track the ground vibration. The sensitivity of the homemade vertical seismometer is approximately 15751 V/g. The bandwidth of the system is 80 Hz. The homemade vertical seismometer is integrated into the homemade T-1 absolute gravimeter to test its performance. The standard deviation of the measurement results is reduced by a factor of 16, when compared with the results obtained without any vibration treatment. Absolute gravimeters with the homemade vertical seismometer are expected to be used in field measurements.
Regarding microwave frequency standards based on trapped ions, we report on the determination of the hyperfine splittings and the Landé factors of . The hyperfine splittings and Landé factors of the and states of are calculated using the multiconfiguration Dirac-Hartree-Fock scheme. Furthermore, the hyperfine splittings of the state of are derived based on the laser-induced fluorescence spectroscopy. The ions are confined in a linear Paul trap and sympathetically cooled by laser-cooled ions. The calculated values and the derived values are cross-checked, thereby guaranteeing the reliability of our results. The results provided in this paper can improve the signal-to-noise ratio of the clock transition and the accuracy of the second-order Zeeman shift correction, thus further improving the stability and accuracy of the microwave frequency standards based on trapped ions.