This paper describes a short-reach serial link to connect chips mounted on the same package or on neighboring packages on a printed circuit board (PCB). The link employs an energy-efficient, single-ended ground-referenced signaling scheme. Implemented in 16-nm FinFET CMOS technology, the link operates at a data rate of 25 Gb/s/pin with 1.17-pJ/bit energy efficiency and uses a simple but robust matched-delay clock forwarding scheme that cancels most sources of jitter. The modest frequency-dependent attenuation of short-reach links is compensated using an analog equalizer in the transmitter. The receiver includes active-inductor peaking in the input amplifier to improve overall receiver frequency response. The link employs a novel power supply regulation scheme at both ends that uses a PLL ring-oscillator supply voltage as a reference to flatten circuit speed and reduce power consumption variation across PVT. The link can be calibrated once at an arbitrary voltage and temperature, then track VT variation without the need for periodic re-calibration. The link operates over a 10-mm-long on-package channel with -4 dB of attenuation with 0.77-UI eye opening at bit-error rate (BER) of 10⁻¹⁵. A package-to-package link with 54 mm of PCB and 26 mm of on-package trace with -8.5 dB of loss at Nyquist operates with 0.42 UI of eye opening at BER of 10⁻¹⁵. Overall link die area is 686 μm x 565 μm with the transceiver circuitry taking up 20% of the area. The transceiver's on-chip regulator is supplied from an off-chip 950-mV supply, while the support logic operates on a separate 850-mV supply.
13 December 2023 in IEEE Journal of Solid-State Circuits
This article presents an inverter-based short-reach ac-coupled toggle (ISR-ACT) link targeted for short-reach die-to-die communication over silicon interposer or similar high-density interconnect. The ISR-ACT’s transmitter (TX) sends non-return-to-zero (NRZ) data through a small series capacitor to inject low-swing pulses into the line. These pulses are amplified and latched by a two-stage receiver (RX), where the 1st-stage transimpedance amplifier (TIA) amplifies the pulse data and positive feedback around both stages captures the data and maintains the dc level on the line. Achieving low signal swing through a capacitor divider, the ACT driver consumes less than half the power compared to regular rail-to-rail CMOS drivers while providing dc voltage isolation between the driver and the RX. Fabricated in a 5-nm standard CMOS process, the ISR-ACT link, operating on a 0.75-V supply, shows 0.66 UI margin at 25.2 Gb/s/wire over a 1.2-mm on-chip channel and demonstrates an energy efficiency of 0.190 pJ/bit.
1 January 2026 in IEEE Journal of Solid-State Circuits