This article presents a clock-forwarded, inverter-based short-reach simultaneous bi-directional (ISR-SBD) physical layer (PHY) targeted for die-to-die communication over silicon interposers or similar high-density interconnect. Short-reach links of this type are increasingly important to support larger systems built with chiplets and multiple die and to facilitate the shift to medium- and long-range optical communication based on silicon photonics. This project explores the advantages of simultaneous bi-directional signaling (SBD) over other bandwidth-doubling techniques (e.g., PAM4). Fabricated in a 5-nm standard CMOS process, the ISR-SBD PHY demonstrates 50.4 Gb/s/wire (25.2 Gb/s each direction) and 0.297 pJ/bit on a 750-mV supply over a 1.2-mm on- chip channel.
13 December 2023 in IEEE Journal of Solid-State Circuits
This article presents an inverter-based short-reach ac-coupled toggle (ISR-ACT) link targeted for short-reach die-to-die communication over silicon interposer or similar high-density interconnect. The ISR-ACT’s transmitter (TX) sends non-return-to-zero (NRZ) data through a small series capacitor to inject low-swing pulses into the line. These pulses are amplified and latched by a two-stage receiver (RX), where the 1st-stage transimpedance amplifier (TIA) amplifies the pulse data and positive feedback around both stages captures the data and maintains the dc level on the line. Achieving low signal swing through a capacitor divider, the ACT driver consumes less than half the power compared to regular rail-to-rail CMOS drivers while providing dc voltage isolation between the driver and the RX. Fabricated in a 5-nm standard CMOS process, the ISR-ACT link, operating on a 0.75-V supply, shows 0.66 UI margin at 25.2 Gb/s/wire over a 1.2-mm on-chip channel and demonstrates an energy efficiency of 0.190 pJ/bit.
A closed loop self-tuning 256kb 6T SRAM with 0.38V-1.2V extended operating range using combined read and write assists and canary-based V MIN tracking is presented. 337X and 4.3X power reductions are achieved using multiple assists and V MIN tracking, respectively; combining both saves 1444X in active power and 12.4X in leakage at the 0.38V.