21 June 2024 in IEEE Microwave and Wireless Technology Letters
A millimeter-wave CMOS active vector-sum phase shifter (VSPS) with a phase resolution of 5.625 $^{\circ}$ using a two-stage transformer-based resistor and inductor (RL) polyphase filter (PPF) for generating wideband in-phase/quadrature (I/Q) signals is proposed. Theoretical analysis demonstrates that the inductors in RL PPF can resonate with the capacitive loads to boost the passive voltage gain and alleviate the issue of high loss in the traditional RC PPF. Furthermore, the RL PPF provides a larger bandwidth and a better tolerance to process variations. An active VSPS prototype incorporating the proposed RL PPF is implemented in 65-nm CMOS process. The measured results of the phase shifter show a maximum insertion gain of $-$ 2.28 dB with a maximum power consumption of 20.52 mW. The measured root-mean-square (rms) phase error and gain error over the 360 $^{\circ}$ phase shifting range are 0.71 $^{\circ}$ –2.95 $^{\circ}$ and 0.67–0.76 dB, respectively, from 20 to 30 GHz (FBW $=$ 40%). The core size is 0.238 mm $^{2}$ .
27 February 2025 in IEEE Transactions on Microwave Theory and Techniques
This article presents a dual-mode, dual-band power amplifier (PA) capable of covering both the fifth-generation (5G) FR1 and FR2 bands for 5G user equipment driver applications. The common-mode (CM) path, often overlooked in a typical differential-mode (DM) CMOS PA, is analyzed and utilized as an alternative path to cover a second frequency band. A universal topology is proposed for the utilization of both DM and CM in PA and other RF circuits. By assigning the millimeter-wave (mm-Wave) and sub-7 GHz bands to DM and CM paths, respectively, this PA achieves coverage of both 3.5 and 27 GHz bands with only one amplifying stage and consequently a compact layout. On the DM path, the proposed PA achieves a P1 dB and PAE1 dB of 18.1 dBm and 32.4% at 24 GHz, while on the CM path, the corresponding performance is 15.3 dBm and 35.5% at 3.7 GHz. The proposed PA exhibits an adjacent channel leakage ratio (ACLR) of -25.9 dBc, an average power-added efficiency (PAE) of 17%, and an average output power of 12.4 dBm at -24.7 dB EVMRMS with a 64 QAM 200 MSym/s modulation signal at 26 GHz in DM. Similarly, with 256 QAM 50 MSym/s modulation at 3.6 GHz in CM, the PA demonstrates -35.6 dBc ACLR, 22.5% average PAE, and 10.7 dBm average power at -31.1 dB EVMRMS. Furthermore, measurements with two carriers at 24 and 3.7 GHz indicate that the PA has the potential for concurrent operation in both modes. The PA is fabricated in a 65 nm CMOS process with a core area of 0.32 mm2.
5 November 2024 in IEEE Transactions on Microwave Theory and Techniques
A novel wideband $I/Q$ network with multiple phase error zeros (MPEZs) is proposed and adopted in a millimeter-wave (mmW) mixer design for high image rejection. The single-ended (SE) MPEZs $I/Q$ network combines topologies of low-pass network and bandpass network. Compared to the conventional $I/Q$ network, our design introduces an inductor $L_{{C}}$ in the bandpass network ( $I$ -path) to improve the bandwidth by generating a new phase error zero. Meanwhile, a capacitor $C_{{C}}$ is inserted in the low-pass network ( $Q$ -path) to assist in optimizing the quadrature performance. Furthermore, a differential form of MPEZs $I/Q$ network is constructed and further improves the bandwidth and amplitude errors. In the differential structure, $L_{{C}}$ can make the voltage gain of $I$ -and $Q$ -paths close to each other to reduce the amplitude error. $C_{{C}}$ primarily affects the voltage gain of the $Q$ -path but has little impact on the voltage gain of the $I$ -path which can accommodate to slightly optimize the amplitude error. A mmW image rejection mixer (IRM) using the proposed differential $I/Q$ network was implemented by the TSMC 65 nm CMOS process. The mixer achieves a measured image-rejection ratio (IRR) higher than 40 dB within a bandwidth from 23.5 to 29.5 GHz (22.6%). It also shows a measured conversion gain (CG) of about 15.5 dB under 5 dBm local oscillator (LO) power, IP1 dB around $-$ 20 dBm, and the IIP3 from $-$ 14.2 to $-$ 12.8 dBm. The power consumption of the mixer with all buffers is 108 mW and the whole chip occupies 0.525 mm $^{{2}}$ .
25 April 2025 in IEEE Transactions on Circuits and Systems I: Regular Papers
This paper presents a 6-bit bidirectional variable-gain vector-summing active phase shifter (BVG-AVSPS) in TSMC 65nm CMOS technology. The proposed BVG-AVSPS consists of a novel bidirectional quadrature generator, four dual-function bidirectional amplifiers and two input/output matching networks. The proposed hybrid-based quadrature generator achieves low orthogonal amplitude and phase mismatches over a wideband with bidirectionality. Dual-function bidirectional amplifiers are employed to achieve either vector modulation or gain control functions in different operational directions. To improve the phase shifting accuracy during gain tuning, compensation transistors are employed in the dual-function bidirectional amplifiers to minimize additional phase variation. The proposed input/output networks based on L-type coupled inductors ensure proper impedance matching for both input and output in TX and RX modes. For both TX and RX modes over 24 GHz~32 GHz, the measured RMS phase and gain errors are 1.25∘~2.4∘ and 0.42 dB~0.56 dB throughout 12.3 dB gain tuning range, respectively. With the help of the compensation transistors, measured phase variation is less than ±2.1∘ during output gain tuning. The core area of proposed BVG-AVSPS is 625 µm×355 µm.
26 August 2025 in IEEE Microwave and Wireless Technology Letters
An active vector-sum phase shifter (VSPS) using a wideband I/Q network and a vector synthesizer with output impedance compensation is presented in this letter. A differential quadrature all-pass filter (QAF) with additional inductors $L_{C}$ and capacitors $C_{C}$ exhibits wideband performance and robustness against load effect. To achieve stable output impedance of the vector synthesizer at different phase states, an impedance compensation structure using a pair of dummy transistors is connected in parallel at the output of the Gilbert cell-based vector synthesizer. The VSPS prototype is implemented in 65-nm CMOS process, which exhibits a measured maximum rms gain error of 0.55 dB and an rms phase error of less than 2.1° with a phase resolution of 5.625° over 2441 GHz. The fractional bandwidth (FBW) is 52.3%. The power consumption is 11.2 mW, and the core size of the whole chip is 0.144 mm2.