25 October 2017 in Journal of Lightwave Technology
High-performance normal-incidence p-i-n Ge photodetectors for 1550 and 1310 nm were grown by selective epitaxial growth on SOI substrate with in situ thermal annealing and surface Si passivation. Bulk leakage current density and surface leakage density as low as 3.4 mA/cm$^2$ and 0.4 μA/cm are achieved under -1 V, respectively. Resonance optical responsivity at 1550 and 1310 nm are 0.27 and 0.59 A/W under zero-bias, respectively. A 3-dB bandwidth as high as 48 GHz is obtained at -3 V. Clear open eye diagrams at 40 Gbps are demonstrated under zero-bias at 1550 nm.
11 June 2001 in Applied Physics Letters
10 November 2008 in Applied Physics Letters
We have fabricated and characterized GaN-based vertical cavity surface emitting lasers (VCSELs) with a unique active region structure, in which three sets of InGaN asymmetric coupled quantum wells are placed in a half-wavelength (0.5λ) length. Lasing action was achieved under optical pumping at room temperature with a threshold pumping energy density of about 6.5mJ∕cm2. The laser emitted a blue light at 449.5nm with a narrow linewidth below 0.1nm and had a high spontaneous emission factor of about 3.0×10−2. The results indicate that this active region structure is useful in reducing the process difficulties and improving the threshold characteristics of GaN-based VCSELs.
8 October 2024 in IEEE Journal of Emerging and Selected Topics in Power Electronics
With the widespread utilization of renewable energy sources, the virtual synchronous generator (VSG) with self-synchronization grid-connection capability has received significant attention. As the core component for power conversion, IGBTs have been a focal point of research due to their susceptibility to failure, affecting reliability and lifespan. Existing studies have managed to control internal IGBT chip junction temperature and extend lifespan through appropriate active thermal control methods. However, these methods either alter the structure of the original IGBT module or fail to compensate for the degradation in power quality. Additionally, they neglect the impact of long-term thermal cycling induced by fundamental frequency current on periodic junction temperature fluctuations. Therefore, this paper proposes an active thermal control method for internal IGBTs in VSG based on switching frequency modulation. This method reduces the average junction temperature of the IGBT and additionally periodic junction temperature fluctuation to some extent. Finally, the proposed method is validated through simulation and experimentation. The experimental results prove the effectiveness of the proposed method.
11 July 2012 in Discover Nano
Four-bilayer Ge quantum dots (QDs) with Si spacers were grown on Si(001) substrates by ultrahigh vacuum chemical vapor deposition. In three samples, all Ge QDs were grown at 520 °C, while Si spacers were grown at various temperatures (520 °C, 550 °C, and 580 °C). Enhancement and redshift of room temperature photoluminescence (PL) were observed from the samples in which Si spacers were grown at a higher temperature. The enhancement of PL is explained by higher effective electrons capturing in the larger size Ge QDs. Quantum confinement of the Ge QDs is responsible for the redshift of PL spectra. The Ge QDs’ size and content were investigated by atomic force microscopy and Raman scattering measurements.
12 July 2024 in IEEE Transactions on Power Electronics
The LLC resonant converter offers several advantages, including compact size, low losses, and high efficiency. These attributes make it an ideal choice for use in seafloor observation networks where space is limited and efficient heat dissipation is crucial. However, the reliability of the LLC converter is compromised due to the susceptibility of the primary switch to failure. In response to this issue, this article proposes a precise open-circuit fault diagnosis (OCFD) method for phase-shifted LLC resonant converters using the integral of the bridge arm midpoint voltage, aiming to identify the fault location and facilitate maintenance. First, the characteristics of the primary-side switch fault in the LLC resonant converter are analyzed in detail, and the characteristic quantity required for fault diagnosis is selected. Subsequently, the OCFD method is introduced, which exclusively depends on the integral value of the voltage at the midpoint of the primary-side switching bridge arm. Following this, a diagnostic circuit is designed to process the bridge-arm midpoint voltage and precisely pinpoint the faulty switch. Finally, the experimental verification is performed on the LLC resonant converter prototype. The results demonstrate that the proposed method can swiftly detect and locate faults within two switching cycles when the LLC converter operates at 100 kHz.