This study aimed to investigate the influence of bimodal TiO2/nanoTiO2 coatings obtained in the PVD/ALD hybrid process on an Al-Si-Cu-type aluminium alloy on the physicochemical properties of the investigated materials. The reference materials were uncoated substrates and samples coated with TiO2 coatings in single PVD and ALD processes. Tests were carried out on the morphology of coatings using scanning electron microscopy (SEM) and atomic force microscopy (AFM) to determine the structure of the tested coatings and their influence on physicochemical properties. The tests of physicochemical properties were carried out using the potentiodynamic and electrochemical impedance spectroscopy methods. The analysis of corrosion products obtained during the study of physicochemical properties was performed using SEM and EDS analysis. Based on the analysis of anode polarisation curves of the tested materials and Tafel analysis, it was found that a sample demonstrated the highest corrosion resistance with a bimodal coating-type TiO2/nanoTiO2, which had the lowest value of corrosion current and the highest value of polarisation resistance. The slightest corrosion resistance was characteristic for uncovered samples. Moreover, the influence of the tested coatings on the improvement of tribological contact of the surfaces of the coated materials with the counter-specimen made of cemented carbides was demonstrated.
The use of a new method of attaching fixed blades to a stator disc led to the need for evaluating the strength of a riveted joint. Conventional mechanical testing revealed large variations in the strength of this joint. After sectioning the jo...
There are a large number of special methods for exploring the internal condition of materials on the basis of eddy currents. A major use of this method can be seen in surface engineering, particularly in studying some state quantities of surfa...
The materials used in VVER nuclear power plants are subject to thermal ageing in operation, among other degradation mechanisms. The aim of the experiment was to verify the effect of thermal ageing on the change of ultrasound velocity on the extracted parts of main circulation piping and pressurizer surge line made of austenitic steels. Two steel conditions were evaluated, as received and thermally aged. The research was carried out on samples made from non-operated pipelines and samples from pipelines after 28 years of operation. The samples were subjected to thermal ageing at 450 °C in an atmospheric furnace with a specified exposure time to simulate extended operation of the component for 60 years, where 1 year of operation means 10 months at 100 %-unit power and 2 months in shutdown. The samples were subjected to ultrasonic property measurements and the longitudinal and transverse wave velocities obtained are further used to calculate the Poisson's constant and elastic modulus E of the material. To verify the ultrasonic measurements, the samples were also subjected to mechanical tests to verify the changes in the mechanical properties in terms of elastic behaviour of the selected steels when subjected to a static 3-point flexural test and Electron backscatter diffraction analysis (EBSD). Ultrasound speed Thermal ageing Elastic modulus E Tree-point flexural test Elastic stiffness coefficient
30 December 2025 in Materials Today Communications
The article deals with the possibility of increasing mechanical and utility properties by means of regenerative heat treatment. Experimental program is focused on the heat treatment of low-alloy heat resistant steel EN ISO 14MoV6-3. Currently, due to significant metallographic changes, this steel is already in most cases operated in a very brittle state as a result of operational degradation. The high brittleness of the steel in operation is the source of frequent failures in the piping systems of coal-fired power plants. For this reason it is highly desirable to achieve an increase in its toughness through appropriate heat treatment and thereby achieve an adequate increase in the remaining service life. It should be noted that increasing the residual life using heat treatment is much more economically advantageous and also less time-consuming compared to the implemented repairs of sudden failures. When designing the heat treatment procedure it is also necessary to respect the specifics of heating and cooling of massive material such as thick-walled pipes. In addition the heat treatment process must be feasible directly at the location of the pipeline structure.