23 December 2024 in Advanced Materials
Mn‐rich disordered rocksalt materials with Li‐excess (DRX) materials have emerged as a promising class of earth‐abundant and energy‐dense next‐generation cathode materials for lithium‐ion batteries. Recently, an electrochemical transformation to a spinel‐like “δ” phase has been reported in Mn‐rich DRX materials, with improved capacity, rate capability, and cycling stability compared with previous DRX compositions. However, this transformation unfolds slowly over the course of cycling, complicating the development and understanding of these materials. In this work, it is reported that the transformation of Mn‐rich DRX materials to the promising δ phase can be promoted to occur much more rapidly by electrochemical pulsing at elevated temperature, rate, and voltage. To extend this concept, micron‐sized single‐crystal DRX particles are also transformed to the δ phase by the same method, possessing greatly improved cycling stability in the first demonstration of cycling for large, single‐crystal DRX particles. To shed light on the formation and specific structure of the δ phase, X‐ray diffraction, scanning electron nanodiffraction (SEND) and atomic resolution STEM‐HAADF are used to reveal a nanodomain spinel structure with minimal remnant disorder.
26 February 2024 in Advanced Materials
Calcination is a solid‐state synthesis process widely deployed in battery cathode manufacturing. However, its inherent complexity associated with elusive intermediates hinders the predictive synthesis of high‐performance cathode materials. Here, correlative in situ X‐ray absorption/scattering spectroscopy is used to investigate the calcination of nickel‐based cathodes, focusing specifically on the archetypal LiNiO2 from Ni(OH)2. Combining in situ observation with data‐driven analysis reveals concurrent lithiation and dehydration of Ni(OH)2 and consequently, the low‐temperature crystallization of layered LiNiO2 alongside lithiated rocksalts. Following early nucleation, LiNiO2 undergoes sluggish crystallization and structural ordering while depleting rocksalts; ultimately, it turns into a structurally‐ordered layered phase upon full lithiation but remains small in size. Subsequent high‐temperature sintering induces rapid crystal growth, accompanied by undesired delithiation and structural degradation. These observations are further corroborated by mesoscale modeling, emphasizing that, even though calcination is thermally driven and favors transformation towards thermodynamically equilibrium phases, the actual phase propagation and crystallization can be kinetically tuned via lithiation, providing freedom for structural and morphological control during cathode calcination.
6 April 2023 in The Journal of Physical Chemistry C
1 April 2002 in Physical Review Letters
We report the results of x-ray diffraction and small angle scattering studies of Ar and Kr confined in sol-gel and Vycor glasses. The confined liquid crystallizes in a disordered hcp structure on freezing. Upon further cooling a sharp transition occurs at a reduced temperature of , where the crystalline structure disappears and the total scattering decreases. This behavior marks the onset of a well-defined mobility transition, where the confined sample migrates out of the pore space.
15 June 1999 in Physical Review B
Synchrotron x-ray scattering has been used to investigate the structure and growth of perhaps the simplest of all films: xenon physisorbed on the Ag(111) surface. High-resolution x-ray scans of the in-plane structure and lower-resolution scans (specular and nonspecular) of the out-of-plane order were performed. The Xe films were prepared under both quasiequilibrium and kinetic growth conditions, and have fewer structural defects than those investigated previously by others on graphite substrates. Under quasiequilibrium conditions, the bulk Xe-Xe spacing is reached at monolayer completion, and the monolayer and bilayer lattice constants at coexistence are inferred equal to within 0.005 Å, consistent with theoretical calculations. The Xe/vacuum interface profile for a complete monolayer and bilayer grown at quasiequilibrium is found to be sharper than for kinetically grown films. At coverages above two layers, diffraction scans along the rod for quasiequilibrated films are consistent with the presence of two domains having predominantly an ABC stacking sequence and rotated 60° with respect to each other about the surface normal. Annealing of these films alters neither the population of the two domains nor the fraction of ABA stacking faults. The thickest film grown under quasiequilibrium conditions exceeds 220 Å (resolution limited). Under kinetic growth conditions, x-ray intensity oscillations at the Xe anti-Bragg position of the specular rod are observed as a function of time, indicating nearly layer-by-layer growth. Up to four complete oscillations corresponding to a film of eight layers have been observed before the intensity is damped out; the number of oscillations is found to depend on the substrate temperature, the growth rate, and the quality of the Ag(111) substrate. The specular reflectivity from kinetically grown films at nominal coverages of three and four layers has been analyzed using a Gaussian model which gives a film thickness standard deviation of 0.5 and 1.0 layers, respectively. Diffraction scans along the rod of these films indicate a larger fraction of ABA stacking faults than found for thicker films. These results demonstrate the difficulty of kinetically growing Xe films thicker than two layers which have an ideal slab geometry.
4 September 2022 in Advanced Materials Interfaces