Marijn Verbeke

Marijn Verbeke

Auto-generated profile, based on publicly available information

Marijn Verbeke

Department of Information Technology, IDLab Design Group, Ghent Universityimec, Ghent, Belgium

Research Focus & Metrics

Academic Career Length

13Years (2014-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
19 December 2017 in Journal of Lightwave Technology
Verified
Journal Article
Closed access
MVMarijn Verbeke
Marijn Verbeke
PRPieter Rombouts
Pieter Rombouts
HRHannes Ramon
Hannes Ramon
JVJochem Verbist
Jochem Verbist
JBJohan Bauwelinck
Johan Bauwelinck
GTGuy Torfs
Guy Torfs
The upcoming 100 Gb/s links in the next-generation ethernet passive optical networks will be based on four channels of 25 Gb/s. The corresponding transceivers in these optical links require a high-speed clock and data recovery circuit to extract a synchronous clock and recover the received data. To achieve a sufficiently fast settling time for 25 Gb/s burst mode upstream applications in passive optical networks (PONs), we introduce an architecture of the first 25 Gb/s all-digital clock and data recovery circuit (AD-CDR). Thanks to the implementation of a digital loop filter, our AD-CDR avoids the need of a system clock or a start-of-burst signal. This circuit is implemented in a 40-nm CMOS process and has a very compact active chip area of only 0.050 mm 2 . Furthermore, the performance of the burst-mode operation of our AD-CDR in an optical setup is measured and reported, resulting in a burst-mode lock time of 37.5 ns and consuming only 46 mW.

6 October 2017 in IEEE Journal of Solid-State Circuits
Verified
Journal Article
Closed access
MVMarijn Verbeke
Marijn Verbeke
PRPieter Rombouts
Pieter Rombouts
HRHannes Ramon
Hannes Ramon
BMBart Moeneclaey
Bart Moeneclaey
XYXin Yin
Xin Yin
GTGuy Torfs
Guy Torfs
Recently, there has been a strong drive to replace established analog circuits for multi-gigabit clock and data recovery (CDR) by more digital solutions. We focused on phase locked loop-based all-digital CDR (AD-CDR) techniques which contain a digital loop filter (DLF) and a digital controlled oscillator (DCO) and pushed the digital integration up to a level where our DLF is entirely synthesized. To enable this, we found that extensive subsampling can be used to decrease the speed of the DLF while maintaining a good operation. Additionally, an Inverse Alexander phase detector and a 5.5-bit resolution DCO complete the AD-CDR architecture. As a result of the low complexity and digital architecture, the AD-CDR occupies a compact active chip area of 0.050 mm 2 and consumes only 46 mW at 25 Gb/s. This is the smallest area and the lowest power consumption compared with the state-of-the-art. In addition, our implementation is highly tunable due to the synthesized logic, and supports a wide operating range (12.5-25 Gb/s), which is a significantly larger range compared with the previous work. Finally, thanks to our digital architecture, the power dissipation decreases linearly while moving to the lower speeds of our operating range. This is in contrast with the most prior work, making our design truly adaptive.

22 December 2023 in IEEE Transactions on Microwave Theory and Techniques
Verified
Journal Article
Closed access
SNShengpu Niu
Shengpu Niu
RARiaz Ahmed
Riaz Ahmed
JLJoris Lambrecht
Joris Lambrecht
JDJakob Declercq
Jakob Declercq
MVMarijn Verbeke
Marijn Verbeke
XYXin Yin
Xin Yin
This article investigates a linear differential modulator driver for optical communication links beyond 120 GBd. The driver was implemented in a 55-nm SiGe BiCMOS technology with an $f_T$ / $f_{\text{MAX}}$ of 330/370 GHz, featuring a traveling wave output stage driven by a lumped variable gain amplifier (VGA) and a predriver. The fabricated IC achieved a maximum low-frequency gain of 21.8 dB with more than 10-dB gain control capability and a 3-dB bandwidth of over 70 GHz. Power measurement results show the driver is able to deliver a constant output swing of 3.56 Vppd while keeping the THD below 2%, with the differential input swing varying from 0.3 to 1.03 Vppd at 1 GHz. In the large-signal measurement, the chip delivered 72, 106, 112, and 128 GBd pulse amplitude modulation-4 (PAM-4) signals with differential output swings of 4, 3.59, 3.434, and 3.425 Vppd, respectively. The chip’s total power consumption is 725 mW, resulting in a power efficiency of 2.83 pJ/bit. Overall, this is the first time an optical modulator driver reported the ability to accommodate such a wide input swing and demonstrated the operation at a data rate of 256 Gb/s. These features make it a desired candidate for beyond 120-GBd optical links.

30 October 2020 in IEEE Transactions on Circuits and Systems I: Regular Papers
Verified
Journal Article
Closed access
MVMarijn Verbeke
Marijn Verbeke
GTGuy Torfs
Guy Torfs
PRPieter Rombouts
Pieter Rombouts
Reception of 4-level pulse amplitude modulation (PAM-4) requires a clock and data recovery (CDR) circuit, typically implemented by a PLL-like structure. An essential block in such a CDR is the phase detector which should detect whether the recovered clock leads or lags the incoming data edges. In typical implementations an incoming data edge is detected by sensing whether the incoming waveform crosses a data threshold level. However, there is some ambiguity in detecting the incoming data edge because PAM-4 modulation has 3 thresholds. If the waveform crosses multiple threshold levels, the level crossings will occur at different time instants due to the finite rise/fall time of the incoming waveform. In this work, we first analyze qualitatively and quantitatively CDR systems that use one threshold for phase adjustment. Here, eliminating the 2-level transitions decreases the amount of jitter injected by the phase detector. However, the available transitions for phase adjustment are also reduced, which lowers the CDR's robustness. Secondly, for CDR systems using three thresholds, a combination of two techniques: majority voting and elimination of 2-level transitions is investigated. We prove that in this case, the elimination of 2-level transitions is not needed and even gives a worse performance when implemented.

7 May 2015 in IEEE Transactions on Circuits and Systems I: Regular Papers
Verified
Journal Article
Closed access
MVMarijn Verbeke
Marijn Verbeke
PRPieter Rombouts
Pieter Rombouts
AVArno Vyncke
Arno Vyncke
GTGuy Torfs
Guy Torfs
In bang-bang (BB) clock and data recovery circuits (CDR) limit cycles can occur, but these limit cycles are undesired for a good operation of the BB-CDR. Surprisingly, however, a little bit of noise in the system is beneficial, because it will quench the limit cycles. Until now, authors have always assumed that there is enough noise in a BB-CDR such that no limit cycle occurs. In this work, a pseudo-linear analysis based on describing functions is used to investigate this. In particular, the relationship between the input noise and the amplitude of eventual limit cycles is investigated. An important result of the theory is that it allows to quantify the influence of the different loop parameters on the minimal amount of input jitter needed to destroy the limit cycle. Additionally, for the case that there is not enough noise, the worst case amplitude of the limit cycle (which is unavoidable in this case) is quantified as well. The presented analysis exhibits excellent matching with time domain simulations and leads to very simple analytical expressions.

1 November 2016 in Electronics Letters
Verified
Journal Article
Open access
PDF file
MVM. Verbeke
M. Verbeke
PRP. Rombouts
P. Rombouts
XYXin Yin
Xin Yin
GTG. Torfs
G. Torfs
An improved bang‐bang phase detector (PD) for multi Gb/s clock and data recovery (CDR) circuits is presented. The proposed PD is based on inverting the Alexander PD. In a typical subsampled CDR circuit, this Inverse Alexander PD results in a ten times better bit error rate (BER) compared with the conventional Alexander PD. Additionally, in the case of duty‐cycle distorted input data, this Inverse Alexander PD can even reach 20 times better BER compared with the conventional Alexander PD.