Future fusion reactors require a safe, steady state divertor operation. The required detached operation is, in tokamaks with metal walls, usually achieved by seeding of impurities, such as nitrogen. With strong seeding levels, the dominant radiation is emitted from a small, poloidally localized volume inside the confined region, in the vicinity of the X-point. The location of the radiating volume is observed to vary relative to the X-point depending on seeding and power levels, i.e. depending on the degree of detachment. At the ASDEX Upgrade tokamak, the position of the radiator relative to the X-point can be controlled in real time by a modulation of the nitrogen puff level. At a certain height of the radiator above the X-point, an ELM-suppressed regime is observed with minimal reduction of confinement. While the control of the X-point radiator already allows operation in full detachment at a dissipated power fraction of around 95 %, which is required for a future reactor and was previously never achieved in a controlled way, such an ELM-suppressed regime additionally eliminates the challenge of the transient, intolerably high heat fluxes by ELMs. Both requirements are met in the presented regime while maintaining a high energy confinement at high density.
Based on particle and energy balances, a reduced model is derived for the physical mechanisms leading to the occurrence of stable and unstable X-point radiators (XPRs), the latter also known as marfes. The leading roles of the neutral deuterium density in the divertor region for initiating XPRs is highlighted. An access condition is formulated whose parameter dependencies are consistent with experimental observations and which could also apply to the process of divertor detachment. With an exponential increase of the recombination rate at low temperature, the XPR becomes magnetohydrodynamically unstable, leading to a marfe and, possibly, to a disruption. A critical density for marfe occurrence is formulated with the upstream density and safety factor as leading parameters, as in the experiment. Marfes are predicted to be more likely in carbon devices than in impurity-seeded plasmas in tungsten devices. The edge plasma parameter domain where marfes occur resembles that used for active marfe avoidance schemes. Both the XPR and marfe occurrence parameter can be used to guide active discharge control.
The quasi-continuous exhaust (QCE) regime, formerly known as either type-II ELM or small ELM regime is studied in ASDEX Upgrade. The regime is a natural type-I ELM-free H-mode. The operational space of QCE discharges in ASDEX Upgrade with respect to their separatrix conditions and their power exhaust capabilities are presented. A significant broadening of the power fall-off length is observed, correlating to an increased separatrix density and pressure. Moreover, the possible reactor relevance of this regime is demonstrated by expanding the operational space to low edge safety factor and demonstrating the benign tungsten impurity behaviour. A discharge without any type-I ELM from start to end reaching a partially detached divertor at high normalised energy confinement time is presented.
We present a novel concept to tackle the power exhaust challenge of a magnetically confined fusion plasma. It relies on the prior establishment of an -point radiator that dissipates a large fraction of the exhaust power before it reaches the divertor targets. Despite the spatial proximity of the magnetic point to the confinement region, this singularity is far away from the hot fusion plasma in magnetic coordinates and therefore allows the coexistence of a cold and dense plasma with a high potential to radiate. In the compact radiative divertor (CRD) the target plates are placed close to this magnetic point. We here report on high performance experiments in the ASDEX Upgrade tokamak that indicate the feasibility of this concept. Despite the shallow (projected) field line incidence angles of the order of , no hot spots were observed on the target surface monitored by an IR camera, even at a maximum heating power of . And even with the point located exactly on the target surface and without density or impurity feedback control, the discharge remains stable, the confinement good (), hot spots absent, and the divertor in a detached state. In addition to its technical simplicity, the CRD scales beneficially to reactor-scale plasmas that would benefit from an increased volume of the confined plasma, more space for breeding blankets, smaller poloidal field coil currents, and—potentially—an increased vertical stability.