27 March 2026 in Optics & Laser Technology
20 May 2025 in Applied Optics
This study utilized laser processing to prepare a wood-based microfluidic chip incorporating two detection methods (microwave detection and colorimetric spectroscopy detection) for detecting lead ions in solutions. By optimizing CO2 and femtosecond laser processing parameters and ultraviolet bonding processes, preparation of the chip was achieved. Femtosecond laser processing created 5.285 µm capacitive gaps in resistor-inductor-capacitor (RLC) resonant circuits. RLC circuits and a sodium rhodizonate colorimetric method were used to detect lead ions in solutions. Experimental results showed that the dual-mode system exhibited detection limits of 1 µg/L (colorimetry, linear response at 620 nm, ) and 10 µg/L (microwave sensing via the peak frequency changes between 2.5 and 3.2 GHz, with a sensitivity of 0.36 dB/10 µg/L). This study accomplished the precision manufacturing of a wood-based microfluidic chip through laser processing and realized the integration of microwave and spectroscopic detection technologies.
4 August 2026 in Applied Optics
Femtosecond laser processing offers considerable potential for precision dental treatment and restoration, yet the ablation characteristics of different beam types in dentin remain insufficiently understood. This study compared Gaussian- and Bessel-beam processing for the fabrication of dentinal microgrooves. Gaussian-beam processing produced well-defined microgrooves with depths of up to 2179µm. Combining axial focal-position adjustment with array scanning enabled controllable three-dimensional fabrication, with a strong linear relationship between microgroove width and depth (R 2 =0.992). The maximum depth was approximately 1 order of magnitude greater than that obtained using fixed-focus processing. In contrast, under the available laser power and optical configuration, Bessel-beam irradiation at a nominal incident fluence of 2.829J/cm 2 did not produce stable deep ablation. The resulting morphology was mainly associated with cumulative energy deposition rather than efficient material removal. These findings clarify the different processing behaviors of Gaussian and Bessel beams in dentin and provide practical guidance for fabricating deep dentinal microstructures. This work may support the further development of femtosecond-laser techniques for precision dental treatment and restoration.