1 January 2022 in IEEE Access
This paper describes a voltage-mode transmitter that supports both non-return-to-zero (NRZ) and four-level pulse amplitude modulation (PAM4) signal transmission. A 2-tap feed-forward equalizer (FFE) is implemented with PAM4 equalization logic consisting of three stages of logic gates and two separated voltage-mode drivers for multi-level generation. Equalization is performed in both the NRZ and PAM4 signal transmission modes. A prototype chip is fabricated using a 28-nm CMOS process. When transmitting 500-mVp-p signals using the proposed transmitter, 41.13 mW power is consumed from a 1-V power supply during the 32-Gb/s PAM4 transmission.
8 October 2018 in IEEE Access
This paper describes a voltage-mode transmitter that stacks independent non-return-tozero (NRZ) and four-level pulse amplitude modulation (PAM4) drivers for dual channels. The stacked structure can improve the transmitter’s power efficiency owing to its current-recycling capabilities. The PAM4 voltage-mode driver with voltage regulators, implemented to increase data rates, generates multilevel signals. The proposed dynamic load control inside the PAM4 driver minimizes the voltage variation in the output of the regulators, which is caused by variations of the data patterns. A prototype chip was fabricated using a 28-nm CMOS process. The stacked 7-Gb/s NRZ and 14-Gb/s PAM4 transmitters achieved a full aggregate transmission rate of 21 Gb/s, while consuming 12.6 mW from a 1-V power supply. When transmitting 500-mVp-p signals with the proposed transmitter through 2-cm FR4 channels, the eye heights obtained in the NRZ and PAM4 channels were 312 mV and 92 mV, respectively.