2 November 2021 in Journal of Applied Physics
The performance of ultraviolet (UV) laser diodes (LDs) with a low Al mole fraction AlGaN cladding layer was investigated by varying the thicknesses of the waveguide layer. It is found that (1) the loss of carriers in the waveguide layer is much larger than that in blue or green LDs due to the shallower quantum well and consequently a weaker carrier confinement of UV lasers. (2) Carrier loss in the waveguide layer can be suppressed by using a thinner waveguide layer. Therefore, the threshold current of LDs can be reduced. (3) The ultraviolet GaN/AlGaN single quantum well laser diodes lasing at 366 nm are fabricated by using relatively thin AlGaN waveguide layers and low Al mole fraction AlGaN cladding layers.
1 September 2022 in AIP Advances
The reaction between gallium (Ga) and silicon (Si), termed melt-back etching, greatly deteriorates the quality of GaN grown on a Si substrate. In this paper, the mechanism of melt-back etching was investigated layer-by-layer in a GaN/AlN/Si system. It is found that the environment of the reactor plays a critical role in melt-back etching, which may happen as early as during the baking process. Drawing on experimental evidence and analyses, a two-step melt-back etching model is proposed. Finally, optimized pretreatments including an AlN precoating process and reduction in baking temperature were used to successfully solve the etching problem and verify the model.
1 September 2023 in Journal of Applied Physics
We have studied the aging-induced degradation effect and the related mechanism of blue and ultraviolet (UV) laser diodes (LDs). First of all, the F parameter value, leakage current, and yellow luminescence intensity of LDs all increase after 24 h of the aging process, indicating that one of the reasons for the degradation of UV LDs may be the increase of the non-radiative recombination center in the material. Second, irreversible damage may be found on the front cavity surface of the UV and blue LDs. Due to the large UV photon energy, water molecules in the environment atmosphere are ionized to form OH− ions, which combine with dust in air to form SiO2 sediments and then attach to the front cavity surface. In addition, a large photon energy may cause damage to the anti-reflection film on the front cavity surface and lead to a too-high local temperature near the cavity surface, resulting in molten Ga droplets. Both sediment and the precipitation of molten GaN on the cavity surface will directly affect the function of the front cavity surface and the output power of the LD. In order to improve the reliability of the GaN-based UV LDs, it is necessary to reduce the density of material defects, select more stable coating materials on cavity facets, and improve the sealing property of the device package.
28 April 2024 in Journal of Applied Physics
In the cathode luminescence spectroscopic study of AlN thin films grown on c-plane sapphire, we found that the luminescence of 3–4 eV is correlated with O impurities, and it is first enhanced and then weakened with the increase in the temperature. The results of an SIMS test show that the concentration of O impurities in the samples is weakly correlated with the growth conditions but strongly correlated with the surface roughness of the samples at the time of growth. The rougher surface exposes more crystalline plane to the growth environment and different crystalline planes have different absorption capacities for O impurities, leading to an inhomogeneous distribution of O impurities in AlN. This inhomogeneous distribution results in a specific variation in the luminescence intensity of O impurities with temperature.
21 October 2024 in Applied Physics Letters
The failure mechanism of 385 nm GaN-based ultraviolet (UV) laser diodes (LDs) has been investigated. The degradation factors were studied by analyzing scanning electron microscopy (SEM), cathodoluminescence, and transmission electron microscopy (TEM) after aging. In degraded UV LD, degradation is easily observed on the anterior cavity facet, with holes found in the epitaxial GaN material, primarily concentrated in the quantum wells and waveguide regions of the LDs. This shows that the degradation may be closely related to the higher photon energy of the UV laser beam emitted by UV LDs. In the aging process of samples, emission of UV lasers leads to deterioration at the interface and in the semiconductor. This degradation leads to continuous heat accumulation and may create a positive feedback loop. Ultimately, this results in the failure of the UV LD. This study presents a possible major factor for the shorter lifetime of UV LD compared to blue LD. Therefore, it is very significant to improve the interface quality for extending the lifetime of UV LDs.
1 November 2024 in Journal of Applied Physics
The leakage mechanism of solar-blind AlGaN p-i-n photodetectors has been investigated. By studying the temperature-dependent I–V curves, we determined that Poole–Frenkel emission is the main source of the leakage current, and the corresponding trap energy level is 0.61 eV. Cathodoluminescence measurement demonstrates that the leakage current of the device may be related to the deep-level traps in the p-AlGaN layer. An analysis of deep-level transient spectroscopy testing results for p-AlGaN suggests that nitrogen vacancies formed during the epitaxial growth of high Al-content p-AlGaN act as electron traps. The trap potential energy decreases at high reverse bias voltage, making trapped electrons easier to escape, which increases the leakage current.