25 April 2023 in IEEE Journal of Emerging and Selected Topics in Power Electronics
This work combines a 99.2% efficient GaN-based low-voltage fast-switching half-bridge converter with a Si-based high-voltage slow-switching and almost lossless switched capacitor multiplexer using a partial power processing approach to a six-level prototype with 99.74% efficiency. A loss breakdown shows how the ideal partial power processing efficiency is theoretically increased to 99.84% by using four additional voltage levels, but then reduced to the measured efficiency by the additional static and dynamic losses of the multiplexer. For electrocaloric heat pumps, an emerging technology for cooling and heating applications with zero global warming potential, such high charging efficiencies enable a high heat pump system coefficient of performance (COP). Based on available data of electrocaloric lead magnesium niobate (PMN)-based samples, and based on a first-principle and best-case analysis for Carnot-like cycles, it is predicted that the 99.74% electrical charging efficiency in combination with the electrocaloric material data enables to surpass 50% of the thermal Carnot limit (for cooling with a heat pump). Ultra-high efficiency of power converters thus pave the way towards future electrocaloric heat pumps of competitive system performance.
20 January 2021 in IEEE Transactions on Electron Devices
A floating-gate (FG) cell as a circuit-level approach to control the threshold voltage of organic thin-film transistors (TFTs) operated in the transdiode configuration is presented. Charging and discharging of the FG are achieved by controlling the charge leakage through the gate dielectric of one of the organic TFTs that constitute the FG cell. Using programming voltages not exceeding 4 V, systematic tuning of the threshold voltage to values between -0.5 and 2.6 V was achieved. The versatility of the concept is demonstrated by employing organic-TFT-based FG cells as transdiodes with programmable threshold voltage in passive rectifiers and diode-load inverters fabricated on flexible, transparent plastic substrates. Rectifiers with programmable FG cells show flatter frequency response, improved 3-dB point, and reduced ripple compared to conventional rectifiers. Inverters with programmable FG-transdiode load have larger small-signal gain, larger output-voltage swing, and larger noise margins than conventional diode-load inverters.