A careful study of pulsed mode operation of the PHOENIX electron cyclotron resonance (ECR) ion source has clearly demonstrated the reality of an unexpected transient current peak, occurring at the very beginning of the plasma breakdown. This regime was named the preglow, as an explicit reference to the afterglow occurring at the microwave pulse end. After the transient preglow peak, the plasma regime relaxes to the classical steady state one. Argon preglow experiments performed at LPSC are presented. A theoretical model of ECR gas breakdown in a magnetic trap, developed at IAP, showing satisfactory agreement with the experimental results is suggested.
16 May 2016 in Physical Review Accelerators and Beams
This work describes the utilization of an injected ion beam as a diagnostics of the helium plasma of a charge breeder electron cyclotron resonance ion source. The obtained data allows estimating the upper limit for the ion-ion collision mean-free path of the incident sodium ions, the lower limit of ion-ion collision frequencies for all charge states of the sodium ions and the lower limit of the helium plasma density. The ion-ion collision frequencies of high charge state ions are shown to be at least on the order of 1–10 MHz and the plasma density is estimated to be on the order of or higher. The experimental results are compared to simulations of the capture into the helium plasma. The results indicate that the lower breeding efficiency of light ions in comparison to heavier elements is probably due to different capture efficiencies in which the in-flight ionization of the incident ions plays a vital role.
Efficient primary ion sources at ISOL facilities normally produce singly charged ions. This limits the usable mass range for postacceleration due to the A∕Q acceptance of the accelerator. At the ISAC facility at TRIUMF an A∕Q below 7 is desired to avoid further stripping. Thus, charge state breeding is necessary if higher masses are to be accelerated. A 14 GHz ECRIS “PHOENIX” booster has been chosen as a breeder. In order to investigate and optimize its performance under ISAC conditions it has been set up at a test bench equipped with a standard ISAC target-ion-source to produce singly charged ions. A series of measurements has been performed with the noble gases Ar, Kr, and Xe. Efficiencies of more than 6% in the maximum of the charge state distribution after mass separation have been obtained and the emittance of the extracted beam and breeding times have been measured. This article gives a status report on the ongoing measurements.
1 February 2020 in Review of Scientific Instruments
The 1+/n+ method, based on an ECRIS charge breeder (CB) originally developed at the LPSC laboratory, is now implemented at GANIL for the production of Radioactive Ion Beams (RIBs). Prior to its installation in the middle of the low energy beam line of the SPIRAL1 facility, the 1+/n+ system CB has been modified based on the experiments performed on the CARIBU Facility at Argone National Laboratory. Later, it has been tested at the 1+/n+ LPSC test bench to validate its operation performances. Charge breeding efficiencies as well as charge breeding times have been measured for noble gases and alkali elements. The commissioning phase started at GANIL in the second half-year of 2017. It consisted of a stepwise process to test the upgrade of the SPIRAL1 facility from simple validation [operation of Charge Breeder (CB) as a stand-alone source] up to the production of the first 1+/n+ RIB. Thus, this year, a 38mK/38K RIB has been successfully delivered to a physics experiment over a period of 1 week. The yields on the physics target were in the range of ∼2–4 × 106 pps at 9 MeV/u. The target ion source system (TISS) was made of a FEBIAD ion source connected to a hot graphite target. This is the first time a RIB is accelerated with a cyclotron with the 1+/n+ method. Moreover, a production test with the FEBIAD TISS has confirmed the yields measured previously, which validates the extension of the GANIL/SPIRAL1 catalog for a number of isotopes. In parallel, R&D is being performed on new TISSs (e.g., a fast release one, using surface ionization source). Targets are also a subject of ongoing R&D for yield and release time optimization. This contribution will present the new acceleration scheme of the SPIRAL1 facility, which largely extends the palette of RIBs available for nuclear physicists. It will be compared to the ones used at similar ISOL facilities. This facility is more than a simple ISOL facility, and an overview of the new opportunities offered by the upgraded installation will be also discussed.
The conceptual design of a fourth generation hybrid electron cyclotron resonance (ECR) ion source operated at 60 GHz is proposed. The axial magnetic mirror is generated with a set of three Nb3Sn coils, while the hexapole is made with room temperature (RT) copper coils. The motivations for such a hybrid development are to study further the ECR plasma physics and the intense multicharged ion beams’ production and transport at a time when a superconducting (SC) hexapole appears unrealistic at 60 GHz. The RT hexapole coil designed is an evolution of the polyhelix technology developed at the French High Magnetic Field Facility. The axial magnetic field is generated by means of 3 Nb3Sn SC coils operated with a maximum current density of 350 A/mm2 and a maximum coil load line factor of 81%. The ECR plasma chamber resulting from the design features an inner radius of 94 mm and a length of 500 mm. The radial magnetic intensity is 4.1 T at the wall. Characteristic axial mirror peaks are 8 and 4.5 T, with 1.45 T minimum in between.