Here, we propose a fully-metallic implementation of a Luneburg lens operating at Ka-band with potential use for 5G communications. The lens is implemented with a parallel plate that is loaded with glide-symmetric holes. These holes are employed to produce the required equivalent refractive index profile of a Luneburg lens. Glide symmetry and inner metallic pins are employed to increase the equivalent refractive index. The lens is fed with rectangular waveguides designed to match the height of the parallel plate, and it is ended with a flare to minimize the reflections.
31 October 2022 in IEEE Transactions on Antennas and Propagation
Antennas for future communication systems are required to be highly directive and steerable to compensate for the high path loss in the millimeter-wave band. In this work, we propose a linear array of modulated geodesic Luneburg lens (the so-called water drop lens) antennas operating at 56-62 GHz. The lens array antenna features two-dimensional beam scanning with low structural complexity. The lenses are fully metallic and implemented in parallel plate waveguides, meaning that they are highly efficient. Each lens is fed with 13 rectangular waveguides surrounded by glide-symmetric holes to suppress leakage. The lenses provide 110 degree beam coverage in the H-plane with scan losses below 1 dB. In order to scan in the E-plane, we use a feeding network based on a 1:4 power divider and three phase shifters. In this configuration, the array can scan 60 degrees in the E-plane, albeit with higher scanning losses than in the H-plane. The lens array is manufactured and a good agreement between simulated and experimental results is obtained.
12 February 2024 in IEEE Open Journal of Antennas and Propagation
The application of lenses combined with array antennas (also known as dome arrays or dome antennas) to the next generation of terrestrial and satellite communication systems brings a wide range of advantages in terms of improved radiation performance, reconfigurability in the use case, and reduction in power consumption. To facilitate the industrial implementation of dome antennas, highly efficient simulation tools are required. In this paper, we present a streamlined implementation of ray tracing for fast and efficient numerical analysis of the far-field radiation performance of 2D multilayer dielectric lenses combined with phased arrays. Unlike commercial physical-optical methods, our proposed ray-tracing method is capable of computing the effects of internal reflections in the dome in a multilayer configuration. In addition, the method estimates the absorption losses as a result of the Joule effect. To demonstrate the effectiveness of the proposed approach, we provide comparisons of the simulated radiation patterns using our proposed ray tracing with the results obtained from commercial full-wave simulation tools.
9 June 2023 in IEEE Transactions on Antennas and Propagation
Quasi-optical beamformers provide attractive properties for antenna applications at millimetre-wave frequencies. Antennas implemented with these beamformers have demonstrated wide angle switching of directive beams, making them suitable as base station antennas for future communication networks. For these applications, it is essential to ensure a high beam crossover gain to provide a robust service to end users within the steering range. Here, we propose a geodesic generalized Luneburg lens antenna operating from 57 to 67 GHz that provides increased crossover gain compared to previously reported geodesic Luneburg lens antennas. The focal curve of the generalized Luneburg lens can be displaced from the beamformer, allowing for a higher angular resolution in the placement of the feed array along the focal curve. The lens is fed with 21 ridge waveguides with an angular separation of 5.1 degrees, thus providing beam steering in a 102-degree range. The peak realized gain varies from 19 to 21 dBi throughout the steering and frequency ranges and the beam crossover gain is roughly 3 dB below the peak gain. The simulations are experimentally validated.
5 January 2022 in IEEE Transactions on Antennas and Propagation
A phased-array fed reflector antenna system is presented which can be used for mm-wave base station applications. The proposed system is designed to support massive-multi-input–multi-output (MIMO) scenarios within a wide coverage ( $\pm 30^\circ $ ) in the azimuth plane and a limited coverage at the elevation plane. A design and characterization methodology has been established to optimize the system for the operation in various line-of-sight conditions by adopting the maximum-ratio-transmission (MRT) and zero-forcing (ZF) MIMO algorithms. A two-user MIMO case study has been considered for the evaluation of the key system performance metrics, i.e., the effective isotropic radiated power, power consumption, signal-to-noise-ratio (SNR), and signal-to-interference-plus-noise-ratio (SINR). This study demonstrates that the phased-array fed reflector concept has a major advantage over traditional direct-radiating phased-array (DRPA) antennas to reduce energy consumption. In the present example, it requires 12–14 dB less transmitted power as compared with the MRT-beamformed DRPAs for the same SNR, and 26–27 dB less transmitted power relatively to ZF-beamformed DRPA systems for the same SINR. A prototype, employing a 55 cm diameter torus reflector and operating at 28 GHz-band, has been manufactured and tested. The measurement results agree well with simulations.
4 October 2022 in IEEE Transactions on Antennas and Propagation
Here, we propose a low profile polarizing technique integrated in a parallel plate waveguide configuration, compatible with fully metallic geodesic lens antennas. The geodesic shape of the antenna is chosen to resemble the operation of a Luneburg lens. The lens is fed with 11 waveguide ports with 10° separation producing 11 switchable beams in an angular range of ±50°. Two metallic polarizing screens are loaded into the aperture of the antenna to rotate the electric field from vertical linear polarization, which is the polarization of the TEM (transverse electromagnetic) mode supported in the lens, to +45° linear polarization. Since the polarizing unit cells are integrated into the aperture of the antenna, the final design is compact. Additionally, the size of the polarizing unit cells is about 0.55λ at the central frequency of operation making the antenna suitable to produce an array formed of stacked lenses. A prototype of the antenna in the K a -band was manufactured and tested, verifying the performance obtained in simulations.