Active clamp flyback (ACF) converter has been demonstrated that which is better than traditional flyback in high-frequency power-adaptor applications. According to the circuit structure, ACF has two modes, primary resonant ACF (PR-ACF) and secondary resonant ACF (SR-ACF). In order to improve the power density, a high-precision primary side regulation (PSR) constant voltage control method for ACF converter is proposed in this paper. The proposed method not only can be effectively adopted in PR-ACF but SR-ACF converter. The high-precision output voltage is predicted by highly accurate sampling points on primary auxiliary voltage. The applied micro controller environment improves the practicability and increases the power density of the ACF system. To verify the proposed PSR method, a prototype which can be changed to PR-ACF and SR-ACF is designed. The output voltage offset, operation efficiency and dynamic performance are analyzed. The tested results show highprecision output is obtained in ACF converter by using the proposed method, the maximum output voltage deviation which are 4% and 3.5% in PR-ACF and SR-ACF converter, respectively. Moreover, SR-ACF has a higher efficiency compared to PR-ACF converter, and a smaller voltage shoot during dynamic process, but which need a larger regulation time since the additional output inductor.
25 November 2020 in IEEE Transactions on Power Electronics
Critical conduction mode (CrCM) active clamp flyback (ACF) converter is regarded as a good candidate to be applied in high-frequency small power supplies. This paper focuses on the modeling, analysis and controller design of CrCM-ACF converter. The small signal model of the converter is derived based on a zero-input resonant equivalent circuit and extended describing function (EDF) method for the first time, then the obtained full-order model is simplified to a low-order model. This procedure establishes an insightful understanding about the effects of the converter parameters and working conditions. Based on the simplified model, a control loop compensator is designed in a single-loop voltage-feedback control scheme for high dynamic performance. An experimental prototype of digital controlled CrCM-ACF converter is built, the accuracy of the derived model is verified by comparing with experimental and simulation results. The performance of the compensator is experimentally evaluated by applying abrupt load current and reference voltage changes in the operating conditions of the converter. From the experimental results, it is demonstrated that the derived analytical model and designed compensator are effective in regulating the output voltage in CrCM-ACF converter.
20 August 2021 in IEEE Transactions on Power Electronics
Adaptive synchronous rectification (SR) is a good solution to solve duty cycle loss for LLC resonant converter. Usually, whether the synchronous rectifier is turned off prematurely or late can be detected by whether the body diode is conducted on or not. However, when the switching frequency is below the resonant frequency, both SR turning- off prematurely and late may generate body diode conduction (BDC), which will cause logic errors in the conventional adaptive SR strategy. Then, a large reverse current from load to source will occur, which damages the efficiency. To solve the problem, the time-domain modeling of the SR drain-to-source voltage is established to analyze the mechanism of BDC caused by SR turning- off late. Moreover, an improved adaptive SR driving scheme is proposed, which can identify the two different types of BDC and tune SR to be turned off exactly. Finally, a 280 W LLC prototype is built to verify the established model and the proposed SR method. The prototype proves that both the duty cycle loss and the reverse current are eliminated and efficiency improvement of 0.54% is achieved.