7 June 2019 in IEEE Transactions on Industrial Electronics
A new continuous conduction mode (CCM) /discontinuous conduction mode (DCM) hybrid-mode synchronous rectification (SR) flyback converter is proposed in this paper. This converter is realized by adding a combined switch in parallel with the auxiliary winding of the flyback transformer. The added switch is controlled to conduct a short period before the primary switch turns on, which shorts the windings of the transformer. The drain-source (DS) voltage of SR arises rapidly to reach the turn-off threshold voltage inside SR controller and the SR is turned off before the primary switch conducts. In this way, the overlapped period existed in conventional CCM SR flyback converter is eliminated. Meanwhile, the normal operation of SR flyback in DCM is not affected. Detailed theoretical analysis has been presented and verified by a 12V/2.5A CCM/DCM hybrid-mode flyback experimental prototype. The results prove that the efficiency of proposed SR method in CCM can be improved compared with conventional one.
2 October 2019 in IEEE Transactions on Power Electronics
A new primary PWM (pulse width modulation) control strategy for continuous conduction mode (CCM) synchronous rectification (SR) flyback converter is proposed in this letter. The PWM signal for the primary switch has been divided into two pulses in a switching period (dual-pulse PWM, DP-PWM). The first pulse is a fixed narrow pulse which is used to turn off the SR, while the second pulse is a regulated pulse for output voltage regulation. With the proposed DP-PWM control scheme, the shoot-through currents exist on both the primary side and secondary side of the CCM SR flyback converter can be effectively reduced. Meanwhile, the efficiency has been improved obviously. Detailed theoretical analysis has been presented and verified by a 12V/2.5A CCM flyback experimental prototype.
20 April 2020 in IEEE Transactions on Power Electronics
In this paper, the primary-side regulation (PSR) technique to achieve accurate output current in LLC resonant converter has been studied. A novel PSR control scheme for LLC LED driver based on “magnetizing current cancellation method” is proposed. The proposed “magnetizing current cancellation method” can effectively eliminate the effect of magnetizing current in the sampled primary resonant current under both continuous conduction mode (CCM) and discontinuous conduction mode (DCM). Thus, the accurate output current can be estimated on the primary side of LLC resonant converter. The magnetizing current cancellation method for the LLC LED driver with symmetric primary resonant current and asymmetric primary resonant current has been analyzed in detail. Some design considerations have also been presented. After that, a LLC PSR control circuit has been designed out based on the theoretic analysis. Finally, a 48V-78V/1.3A laboratory prototype for LED driver has been built up and experimental results show that good output current regulation has been obtained.