Spin–orbit torque (SOT)-induced reversal of a ferromagnet in a magnetic tunnel junction (MTJ) is promising for next-generation novel magnetic memory and spin-logic devices. However, inherent limitations of single ferromagnetic-based free layer (FL) systems are low thermal stability and susceptibility to external magnetic stray fields. To overcome these challenges, synthetic antiferromagnets (SAFs) are integrated into MTJ devices to form hybrid free layers (HFLs); this FL system enables tunability of thermal stability and stray field experienced by the FL, simultaneously lowering the SOT-induced switching currents. Here, we investigate the impact of net magnetization of the SAF-based HFL on the field and current-driven switching behavior. We observe that nearly compensated SAF-HFL systems demonstrate a higher proportion of switching failures at the device level than the uncompensated SAF-HFL systems in both current and field-driven schemes. Micro-magnetic simulations and thin film characterization of SAF-HFL show that the device-level stochasticity arises due to a dynamic decoupling within the nearly compensated SAF systems. We show that optimizing the SAF-HFL systems to have uncompensated magnetization mitigates this stochasticity and improves the SOT switching current for Pt-based SOT channel by at least 20% across the entire tested pulse width range down to 300 ps, thus leading to reliable switching of SOT-MTJs with SAF-HFL stacks.
Spin orbit torque (SOT) is essential to magnetization modulation in various ferromagnet/non-magnet bilayers. In this study, we demonstrated that SOT can be enhanced in a hybrid system composed of a perovskite oxide NdNiO3 (NNO) and a Ni81Fe19/Pt bilayer. We also find that the SOT enhancement might be attributed to spin absorption at the interface between the NNO and Ni81Fe19 layers. Our findings suggest that metal-oxide hybrid structures can be promising systems for the development of efficient spin–orbitronic devices.
The anomalous Nernst effect (ANE) plays a crucial role in thermoelectric energy conversion. Recent studies have suggested that ANE can be enhanced by increasing magnetic anisotropy, based on investigations of ferromagnetic alloys such as FePt, FePd, and MnGa, which possess varying degrees of magnetic anisotropy. Moreover, it has been reported that interfacial effects can also significantly influence the ANE. However, these materials differ not only in anisotropy but also in other intrinsic properties, leaving it unclear whether uniaxial magnetic anisotropy alone plays a decisive role in enhancing ANE. To isolate the effect of magnetic anisotropy, we studied MgO/Ta/CoFeB/W thin films, where voltage-controlled magnetic anisotropy enables modulation of magnetic anisotropy without altering other material characteristics. Despite a 30% reduction in magnetic anisotropy, we observed less than a 3% change in ANE, indicating a weak correlation. These findings suggest that magnetic anisotropy alone is not a critical factor governing the ANE, and that the ANE remains robust in voltage-tuned devices.