18 February 2020 in Journal of Microelectromechanical Systems
We demonstrate two novel dual-mode ovenized MEMS resonators, each with an in-chip device layer micro-oven that utilizes less than 30mW for resonator temperature control over variations in external temperature from -40°C to +60°C. The device layer micro-oven enables correction for ambient temperature variations and achieves a 1-week frequency stability for the output mode over temperature near 1.5 ppb for the Lamé-mode resonator. The devices were built in the Epi-Seal fabrication process and take advantage of the exceptional long-term stability of MEMS resonators built in that process. These results exceed all prior reports for frequency stability over time and temperature for MEMS resonators and have the potential to impact the development of miniature, low-power time references. [2019-0054]
31 August 2018 in Journal of Microelectromechanical Systems
This paper presents the use of our approach to comprehensive measurements of the quality factor ( $Q$ ) of 1-MHz microelectromechanical system (MEMS) tuning fork resonators. We examined the most important mechanisms that are believed to limit the quality factor in MEMS tuning fork resonators (i.e., gas damping, thermoelastic dissipation (TED), anchor damping, and Akhiezer damping), and we were able to quantitatively account for each mechanism and to eliminate several from consideration. We take advantage of the elimination of TED at ~120 K, where the linear coefficient of thermal expansion (CTE) becomes 0. These observations enabled the first direct examination of the strength of anchor damping in megahertz tuning fork resonators, allowing the study of the effect of anchor design and other factors. In this megahertz frequency range, the wavelength of elastic waves far exceeds the dimensions of the die, so commonly used models cannot make predictions of anchor damping. Our results show that elastic energy can escape from the resonator through the anchor(s) and still be retained within the die. We find that anchor damping in these megahertz resonators is impacted more by die attach structures at the boundaries of the die than by the resonator anchor designs within the die. [2018-0038]
24 October 2017 in Journal of Microelectromechanical Systems
This paper presents a novel wafer-level thin-film encapsulation process that allows both narrow and wide trenches, which are necessary for traditional structures such as comb-drives. Fully functional devices with trench widths up to 50 $\mu \text{m}$ are fabricated by employing a vapor phase XeF2 isotropic silicon etch to create large cavities and an epitaxial deposition seal to encapsulate the devices in an ultra-clean, high vacuum environment with no native oxide and humidity. In this paper, we demonstrate the robustness of the proposed fabrication process, as well as the inherent benefits of the high-temperature epitaxial encapsulation process: high quality factor, extreme stability, exceptional aging, and fatigue performance. [2017-0098]