16 January 2025 in IEEE Transactions on Components, Packaging and Manufacturing Technology
This paper analyzes intermittent partial connection defect in Double data rate 4 (DDR4) memory data channel. DDR4 ball grid array package develops partial connection defect during device operation. Electrical model of defect is presented and Ansys software is used to extract resistance, inductance and capacitance change due to defect radius and defect height variation. Ansys 3-D electromagnetic field solver simulation is done to extract S-parameters of a pair of solder balls having intermittent partial connection defect. It is shown that there is noticeable signal degradation when defect height is above 0.1 um and radius is below 0.1 um values and this will result in intermittent errors. AC coupling behavior appears at small defect radius and 3 dB frequency changes with defect height and radius change. DDR4 data channel architecture is examined to show asymmetric behavior for logic “1” and logic “0”. Data channel response is analyzed in presence of partial connection defect and data eye channel loss and margin loss are used to characterize signal degradation. The area of partial connection is varied to observe the channel response change. As defect height increases, the radius at which DDR4 data specification violation occurs decreases. Data rate is varied to show channel loss increase for higher data rates. Eye margin is calculated to show decrease in low eye margin with data rate increase. DDR4 data channel asymmetric response causes logic “0” bit error rate to increase, whereas logic “1” bit error rate doesn’t change. This behavior can be used as a diagnostic symptom for intermittent partial connection defect detection.
8 September 2025 in IEEE Transactions on Components, Packaging and Manufacturing Technology
Intermittent faults in electronic systems can cause catastrophic failures in mission-critical applications. However, because of the dynamic nature of intermittent faults, most of the errors disappear before they can be analyzed, complicating the identification and resolution of their root cause. In this study, we perform in-situ analysis of intermittent wire-bond defects observed in a complementary metal-oxide semiconductor buffer, to investigate their root cause. The waveform distortions representing various stages of an intermittent wire-bond defect are successfully captured by applying a liquid-nitrogen thermal shock that induces crack propagation because of the mismatched coefficients of thermal expansion. Simulation program with integrated circuit emphasis software is utilized for waveform analysis, and the propagation of nanoscale cracks is analyzed geometrically using a high-frequency structure simulator. Resistance levels ranging from several hundreds of ohms to kilo ohms and crack-induced capacitances up to 10 pF are observed, with the DC resistance contributing significantly to system errors. Moreover, we demonstrate electrical recovery through crack closures resulting from the thermal shock. The combination of crack propagation and closure is determined to be the root cause of intermittent failures. The analysis of wire-bond–defect characteristics, buffer architecture, and measured wire-bond–defect waveforms can help determine the location of the defect. Our results provide new insights into the propagation and recovery mechanisms of wire-bond cracks.
29 April 2026 in IEEE Transactions on Instrumentation and Measurement
This paper presents an effective capacitance measurement based approach for fault analysis of a high speed interface. A faulty retimer chip is systematically investigated, benchmarked against good chips, using a combination of bit error testing (BER) and frequency domain measurements. A custom testing platform was employed to measure BER across all channels, while a dedicated socket enabled subsequent S-parameter characterization. Single-ended S11 response of the p and n-sides of each differential channel were measured and processed to extract input capacitance of receiver interface. Results reveal a strong correlation between capacitance mismatch, S11 mismatch, reduced data eye margins, and BER degradation. Faulty channels with high BER or initialization failures consistently exhibited significant capacitance mismatches, while good devices showed symmetry between p and n-sides of differential channel. These results show capacitance measurement as an effective initial screening and diagnostic method for early fault diagnosis and also as a complement to BER testing.