HyeonU Park

HyeonU Park

Auto-generated profile, based on publicly available information

HyeonU Park

Department of Electronics and Communications Engineering, Highly-Reliable Intelligent System-Semiconductor Education and Research Center for Energy Systems, Hanyang University, Ansan-si, Gyeonggi-do, South Korea

Research Focus & Metrics

Academic Career Length

2Years (2025-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
16 January 2025 in IEEE Transactions on Components, Packaging and Manufacturing Technology
Verified
Journal Article
Closed access
MWMuhammad Waqar
Muhammad Waqar
YCYoung-Bin Chang
Young-Bin Chang
HPHyeonu Park
Hyeonu Park
Sanghyeon BaegSanghyeon Baeg
Sanghyeon Baeg
This paper analyzes intermittent partial connection defect in Double data rate 4 (DDR4) memory data channel. DDR4 ball grid array package develops partial connection defect during device operation. Electrical model of defect is presented and Ansys software is used to extract resistance, inductance and capacitance change due to defect radius and defect height variation. Ansys 3-D electromagnetic field solver simulation is done to extract S-parameters of a pair of solder balls having intermittent partial connection defect. It is shown that there is noticeable signal degradation when defect height is above 0.1 um and radius is below 0.1 um values and this will result in intermittent errors. AC coupling behavior appears at small defect radius and 3 dB frequency changes with defect height and radius change. DDR4 data channel architecture is examined to show asymmetric behavior for logic “1” and logic “0”. Data channel response is analyzed in presence of partial connection defect and data eye channel loss and margin loss are used to characterize signal degradation. The area of partial connection is varied to observe the channel response change. As defect height increases, the radius at which DDR4 data specification violation occurs decreases. Data rate is varied to show channel loss increase for higher data rates. Eye margin is calculated to show decrease in low eye margin with data rate increase. DDR4 data channel asymmetric response causes logic “0” bit error rate to increase, whereas logic “1” bit error rate doesn’t change. This behavior can be used as a diagnostic symptom for intermittent partial connection defect detection.

29 April 2026 in IEEE Transactions on Instrumentation and Measurement
Verified
Journal Article
Closed access
MWMuhammad Waqar
Muhammad Waqar
HPHyeonU Park
HyeonU Park
YCYoung-Bin Chang
Young-Bin Chang
SJSeongyoung Jeon
Seongyoung Jeon
Sanghyeon BaegSanghyeon Baeg
Sanghyeon Baeg
This paper presents an effective capacitance measurement based approach for fault analysis of a high speed interface. A faulty retimer chip is systematically investigated, benchmarked against good chips, using a combination of bit error testing (BER) and frequency domain measurements. A custom testing platform was employed to measure BER across all channels, while a dedicated socket enabled subsequent S-parameter characterization. Single-ended S11 response of the p and n-sides of each differential channel were measured and processed to extract input capacitance of receiver interface. Results reveal a strong correlation between capacitance mismatch, S11 mismatch, reduced data eye margins, and BER degradation. Faulty channels with high BER or initialization failures consistently exhibited significant capacitance mismatches, while good devices showed symmetry between p and n-sides of differential channel. These results show capacitance measurement as an effective initial screening and diagnostic method for early fault diagnosis and also as a complement to BER testing.