29 April 2020 in IEEE Sensors Journal
ANAnupama Vijaya Nadaraja
+4
This work presents the development of a co-planar waveguide based split ring resonator, integrated with a microfluidic channel suitable for liquid sensing ap-plications. The sensor was fabricated via photolithography on a 0.5 mm borosilicate glass substrate with patterned gold. The microfluidic channel was aligned with the sensing area and bonded to the substrate to ensure consistent liquid volume (0.784 μL) over the sensing region. The microwave sensor was 1.5×3 cm2 and had a resonant frequency be-tween 19.3 and 19.4 GHz, offering the advantage of meas-uring extremely small sample volumes. The performance of the sensor was validated through simulations and a series of experiments using a |Z|-probe station. The sensor demon-strated a resonant amplitude sensitivity of -0.085 dB/vol.% for isopropyl alcohol in water (0-100 vol.%), 0.00023 dB/[mg/dL] for various glucose concentrations (50-1200 mg/dL), and 0.00056 dB/[mg/dL] for NaCl in water (50-1200 mg/dL, with equivalent Na+ 9- 226 mEq/L solu-tions); measured under room ambient conditions (24±1 °C and RH: 36±1 %).
1 July 2017 in Water Research
3 October 2023 in IEEE Transactions on Microwave Theory and Techniques
This article presents a highly efficient GaN-based harmonic-tuned multiband RF rectifier for wireless power transfer (WPT) applications. The rectifier has been implemented by incorporating a microstrip coupler and a transmission line-based phase shifter to convert a power amplifier (PA) into a synchronous rectifier based on the time-reversal duality principle. The proposed rectifier provides a compact solution for wireless power charging systems while supporting dual-bands. The microstrip coupler is used to derive the gate driving signal for the device, which requires a weak coupling from the input RF signal. The coupler has been characterized separately for wideband operation from 1 to 3 GHz with only 0.3-dB insertion loss. Measurement results show that the rectifier has 77% and 75% efficiencies at 1.17 and 2.4 GHz, respectively, when the input RF power is 10 W. The rectifier shows $>$ 50% efficiency for input power levels down to 1.5 W. To the best of the authors’ knowledge, this rectifier presents one of the highest RF-to-dc rectification efficiencies in dual-band operation for a watt-level RF input power.
10 October 2017 in IEEE Microwave and Wireless Components Letters
In this letter, two different switching modes are identified for RF synchronous rectifier circuits which lead to a change in the polarity of the rectified output voltage. The operation of the two modes is defined in terms of the dynamic current–voltage (I–V) characteristics of the switching device and the polarity of the output load voltage. In one mode, the dc output voltage is positive and associated with a switching condition where the device is ON in quadrant-III and OFF in quadrant-I. This mode of operation has been reported widely in the literature. In the second mode, the quadrants associated with the on- and off-state are swapped leading to a polarity reversal across the load. Theoretical justification for the two modes is given and the experimental results are shown to confirm the two different switching modes in the synchronous rectifier. Experiments with a GaN inverse class-F rectifier were made to verify the theory, and both modes have similar measured peak rectification efficiencies of 77% at a frequency of 1.8 GHz.