23 October 2018 in IEEE Transactions on Plasma Science
This paper presents a novel three-coil reconnection electromagnetic launcher (TCREL). Analytical calculations and simulation results indicated that not only does this model possess a higher structural strength, but also the launching efficiency is improved effectively compared with that of the traditional reconnection electromagnetic launcher (REL). In addition, take the TCREL model as an independent module; a toroidal REL (TREL) model can be obtained after several modules are uniformly placed and fixed around the circumference. The TREL model can reduce the magnetic flux leakage among driving coils, and further improves the launching efficiency. To verify the conceptual feasibility, two-stage TCREL and REL models were built and tested. The experiments demonstrate that the TCREL model possesses better launching performance than does the REL model; the former can obtain the desired launching efficiency of 15.818% but the latter only 8.248% in the contrast experiment. The experimental results are also in accordance with the simulation results.
10 April 2018 in IEEE Transactions on Applied Superconductivity
In this paper, a magnetic resonance wireless power transfer (WPT) system with two coils using superconductor and ferromagnetic (SC-FM) metamaterials was constructed and tested. SC-FM metamaterials were used in the WPT system to improve the transfer efficiency of the magnetic resonance WPT system. Three kinds of resonance coils were designed and the effects on the WPT system of different resonance coils using SC-FM metamaterials were investigated. This involved designing and conducting several kinds of WPT experiments with, and without, the SC-FM metamaterials. The results are then presented and analyzed. It is shown that the SC-FM metamaterials are able to improve the transfer efficiency of a WPT system.
22 April 2020 in IEEE Transactions on Plasma Science
In the launch process of the multistage synchronous induction electromagnetic launcher (SIEL), the armature is usually accelerated step by step. Due to the impact of high instantaneous electromagnetic force and large acceleration fluctuation, some kinds of sensitive loads may be damaged during the launching process. To reduce the harm that caused by the abovementioned issue, this article proposes an optimized armature and an asynchronous pulse discharge scheme to smooth the acceleration curve based on the toroidal reconnected electromagnetic launcher (TREL). First, a mathematical coupling model of the single-stage TREL is built to describe the energy conversion relationship between the driving coils and the armature. Then, the dynamics characteristics of the TREL model based on two armature structures and two discharge schemes are analyzed through the finite-element method. Finally, the simulation results demonstrate that the large acceleration fluctuation of the armature can be effectively cut down with the proposed methods.
12 April 2019 in IEEE Transactions on Plasma Science
This paper proposes a novel single-stage double-layer saddle multipole field electromagnetic launcher (SSDFEL), which combines the characteristics of reconnection gun to achieve simultaneous linear acceleration and gyroscopic stabilization of the projectile. Since the saddle driving coils are divided into two layers, the magnetic field density inside the launcher is enhanced. The eddy current induced on the inner and outer surfaces of the projectile is greatly changed by the hollow cylindrical projectile with six symmetrical vertical slots twisted at a certain angle, and the projectile is simultaneously propelled to perform rotation motion and linear motion. In this paper, the electromagnetic field finite-element software is used to simulate and calculate this model. The simulation results indicated that the double-layer driving coil distribution has larger axial acceleration force and bigger circumferential torque than that of the single-layer driving coil distribution, the energy conversion efficiency has also been obviously increased, and there is an optimal initial twisted angle, which accelerates the projectile to the peak of rotation. To verify the results, an SSDFEL was established and tested. The experiment results confirm that the rotation performance can be affected by the initial twisted angle and a better launching effect is achieved than a single-layer distribution. In general, the experimental results are in agreement with the simulation results.
31 December 2019 in IEEE Transactions on Plasma Science
For the energy loss issue of the synchronous induction electromagnetic launcher (SIEL) subjected to the traditional driving circuit, a high temperature superconducting magnet (HTSM)-based energy recovery system is proposed in this article to improve the energy management capability for the SIEL. This energy recovery system is composed of half-wave circuit, HTSM, dc chopper, and three-phase full-bridge inverter. If there is a demand to execute the mission of short-term continuous shooting, the HTSM can convert the reverse energy stored in capacitors into forward energy in preparation for the next shot. If the launch mission has ended and no demand of launch again, the dc chopper and the three-phase full-bridge inverter are used to pump the remaining energy back into the grid. Then, a mathematical model of the energy recovery system is established to verify the effectiveness of the above mentioned schemes. The simulation results show that not only does the energy recovery system can realize the reuse of remaining energy in the continuous shooting mission, but also it can complete the unidirectional energy transfer with the grid in unit power factor. Finally, based on the three-coil reconnection electromagnetic launcher (TCREL), a small test platform is built. The transfer process of the remaining energy from the capacitors to the HTSM and the working performance of the dc chopper are mainly tested in here. The experimental results basically verify the effectiveness of the energy recovery system.