Milita Vagner

Milita Vagner

Auto-generated profile, based on publicly available information

Milita Vagner

Department of Functional Materials and Electronics, Center for Physical Sciences and Technology, Sauletekio Ave. 3, 10257 Vilnius, Lithuania

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
25 May 2022 in Sensors
Verified
Journal Article
Open access
PDF file
Nerija ZurauskieneNerija Zurauskiene
Nerija Zurauskiene
Voitech StankevicVoitech Stankevic
Voitech Stankevic
SKSkirmantas Kersulis
Skirmantas Kersulis
MVMilita Vagner
Milita Vagner
VPValentina Plausinaitiene
Valentina Plausinaitiene
AWAndrzej Wisniewski
Andrzej Wisniewski
The results of colossal magnetoresistance (CMR) properties of La1-xSrxMnyO3 (LSMO) films grown by the pulsed injection MOCVD technique onto an Al2O3 substrate are presented. The grown films with different Sr (0.05 ≤ x ≤ 0.3) and Mn excess (y > 1) concentrations were nanostructured with vertically aligned column-shaped crystallites spread perpendicular to the film plane. It was found that microstructure, resistivity, and magnetoresistive properties of the films strongly depend on the strontium and manganese concentration. All films (including low Sr content) exhibit a metal–insulator transition typical for manganites at a certain temperature, Tm. The Tm vs. Sr content dependence for films with a constant Mn amount has maxima that shift to lower Sr values with the increase in Mn excess in the films. Moreover, the higher the Mn excess concentration in the films, the higher the Tm value obtained. The highest Tm values (270 K) were observed for nanostructured LSMO films with x = 0.17–0.18 and y = 1.15, while the highest low-field magnetoresistance (0.8% at 50 mT) at room temperature (290 K) was achieved for x = 0.3 and y = 1.15. The obtained low-field MR values were relatively high in comparison to those published in the literature results for lanthanum manganite films prepared without additional insulating oxide phases. It can be caused by high Curie temperature (383 K), high saturation magnetization at room temperature (870 emu/cm3), and relatively thin grain boundaries. The obtained results allow to fabricate CMR sensors for low magnetic field measurement at room temperature.

23 January 2019 in Beilstein Journal of Nanotechnology
Verified
Journal Article
Open access
PDF file
RDRasuole Lukose (prev. Dirsyte)
Rasuole Lukose (prev. Dirsyte)
VPValentina Plausinaitiene
Valentina Plausinaitiene
MVMilita Vagner
Milita Vagner
Nerija ZurauskieneNerija Zurauskiene
Nerija Zurauskiene
SKSkirmantas Kersulis
Skirmantas Kersulis
ENEvaldas Naujalis
Evaldas Naujalis
In the present study the advantageous pulsed-injection metal organic chemical vapour deposition (PI-MOCVD) technique was used for the growth of nanostructured La1−xSrxMnyO3±δ (LSMO) films on ceramic Al2O3 substrates. The compositional, structural and magnetoresistive properties of the nanostructured manganite were changed by variation of the processing conditions: precursor solution concentration, supply frequency and number of supply sources during the PI-MOCVD growth process. The results showed that the thick (≈400 nm) nanostructured LSMO films, grown using an additional supply source of precursor solution in an exponentially decreasing manner, exhibit the highest magnetoresistance and the lowest magnetoresistance anisotropy. The possibility to use these films for the development of magnetic field sensors operating at room temperature is discussed.

14 June 2021 in IEEE Transactions on Magnetics
Verified
Journal Article
Closed access
Nerija ZurauskieneNerija Zurauskiene
Nerija Zurauskiene
SKSkirmantas Kersulis
Skirmantas Kersulis
VRVakaris Rudokas
Vakaris Rudokas
MVMilita Vagner
Milita Vagner
KMKarolis Motiejuitis
Karolis Motiejuitis
VPValentina Plausinaitiene
Valentina Plausinaitiene
The results of preparation and post-treatment conditions on long-term stability of Co-substituted nanostructured manganite La0.81Sr0.19Mn1.09Co0.06O3 films are presented. The films were grown on polycrystalline Al2O3 substrates by Pulsed-Injection Metal-Organic Chemical Vapor Deposition technique at 600 °C keeping different growth rates (9 nm/min, 13 nm/min, and 27 nm/min) thus inducing different level of disorder in the films. For comparison, the reference epitaxial films were deposited on LaAlO3 substrate. The changes of resistivity and magnetoresistance (up to 20 T) during the long-term storage of the films and accelerated ageing by annealing the films in O2 or Ar atmosphere at ~100 °C were studied. It was found, that the annealing atmosphere and long-term storage has significant influence on the film resistivity and metal-insulator transition temperature, while magnetoresistance magnitude is affected insignificantly. The ageing effects have the highest influence on the nanostructured film grown at the highest growth rate, while for epitaxial films the changes are negligible. The observed changes were analyzed using Mott&s variable range hopping model and explained by oxygen depletion and diffusion in grain boundaries of nanostructured films. The ways to stabilize the main parameters of the manganite-cobaltite films for the development of high magnetic field sensors are discussed.

28 April 2026 in Sensors
Verified
Journal Article
Open access
PDF file
VRVakaris Rudokas
Vakaris Rudokas
MKMykola Koliada
Mykola Koliada
Voitech StankevicVoitech Stankevic
Voitech Stankevic
SKSkirmantas Kersulis
Skirmantas Kersulis
VVVilius Vertelis
Vilius Vertelis
Nerija ZurauskieneNerija Zurauskiene
Nerija Zurauskiene
Magnetic sensors based on the colossal magnetoresistance (CMR) effect in manganite thin films are promising for high-field measurements due to their wide operating range, low magnetoresistance anisotropy, and ability to function without full saturation at extremely high magnetic fields. However, the long-term stability of their transport properties remains a key challenge for practical sensor applications. In this work, accelerated aging of nanostructured La1−xSrxMnyO3 thin films was investigated for two manganese compositions: nominally stoichiometric (y = 1.05) and Mn-excess (y = 1.15). The electrical resistivity and magnetoresistive properties strongly depended on the manganese content and substrate type. Accelerated aging was induced by annealing at 100 °C in an argon atmosphere, and the evolution of the transport properties was analyzed using a stretched-exponential relaxation model. The analysis of the extracted parameters indicated defect-related mechanisms governing transport stability. It was found that despite the increase in resistivity during thermal treatment, the magnetoresistance changes were insignificant. The results provide insights into the aging behavior of nonstoichiometric manganite films and offer guidance for optimizing stabilization procedures in CMR-based magnetic field sensors.

11 May 2026
Verified
Thesis
Closed access
MVMilita Vagner
Milita Vagner
Ši disertacija skirta La1-xSrx(Mn1-yCoy)zO3 (x = 0,20±0,02; z = 1,15) (LSMCO) sluoksnių auginimui ir tyrimui. LSMCO sluoksniai buvo auginami impulsiniu-injekciniu iš metalorganinių junginių cheminės garų fazės nusodinimo (PI-MOCVD) metodu, esant 750 oC nusodinimo temperatūrai. Buvo ištirtos LSMCO sluoksnių struktūrinės, elektrinės ir magnetinės savybės esant nestechiometriniam mangano kiekiui, bei kobalto kiekiui kintant nuo 0 iki 0,17. LSMCO sluoksniai, užauginti ant LaAlO3 padėklo, buvo epitaksiniai, o ant safyro-R ir Al2O3 padėklų – nanostruktūrizuoti. Struktūriniai tyrimai atskleidė, kad priklausomai nuo kobalto kiekio, epitaksiniams LSMCO sluoksniams būdingi tempimo ir suspaudimo įtempimai. Tuo tarpu nanostruktūrizuotuose LSMCO sluoksniuose buvo nustatyti tik tempimo įtempimai. Atlikti elektriniai matavimai parodė, kad epitaksiniams ir nanostruktūrizuotiems LSMCO sluoksniams nustatyta fazinio virsmo temperatūra mažėja, didėjant kobalto kiekiui sluoksnyje. Taip pat, tiek epitaksiniams, tiek nanostruktūrizuotiems LSMCO sluoksniams buvo įvertinta ir kobalto kieko įtaką magnetovaržinėms savybėms, kadangi tai aktualu pažangesnių magnetinių jutiklių vystymui. Tiek struktūrinių, tiek elektrinių ir magnetinių tyrimų rezultatai parodė, kad cheminė sudėtis nulemia LSMCO sluoksnių savybes, todėl buvo lygintos LSMO (La1-xSrxMnzO3) ir LSMCO savybės. Struktūriniai, elektriniai ir magnetiniai tyrimai LSMO ir LSMCO sluoksniams atskleidė, kad epitaksinių sluoksnių pokyčiai priklauso nuo Mn kiekio, tuo tarpu nanostruktūrizuotų sluoksnių pokyčiai susiję su kobaltu. Šio darbo metu taip pat buvo sukurtas trijų sluoksnių grafeno ir LSMCO sluoksnio hibridinio jutiklio prototipas, kuris skirtas matuoti magnetinį lauką kambario temperatūroje plačiame magnetinio lauko diapazone (0,1–20 T).Ši disertacija skirta La1-xSrx(Mn1-yCoy)zO3 (x = 0,20±0,02; z = 1,15) (LSMCO) sluoksnių auginimui ir tyrimui. LSMCO sluoksniai buvo auginami impulsiniu-injekciniu iš metalorganinių junginių cheminės garų fazės nusodinimo (PI-MOCVD) metodu, esant 750 oC nusodinimo temperatūrai. Buvo ištirtos LSMCO sluoksnių struktūrinės, elektrinės ir magnetinės savybės esant nestechiometriniam mangano kiekiui, bei kobalto kiekiui kintant nuo 0 iki 0,17. LSMCO sluoksniai, užauginti ant LaAlO3 padėklo, buvo epitaksiniai, o ant safyro-R ir Al2O3 padėklų – nanostruktūrizuoti. Struktūriniai tyrimai atskleidė, kad priklausomai nuo kobalto kiekio, epitaksiniams LSMCO sluoksniams būdingi tempimo ir suspaudimo įtempimai. Tuo tarpu nanostruktūrizuotuose LSMCO sluoksniuose buvo nustatyti tik tempimo įtempimai. Atlikti elektriniai matavimai parodė, kad epitaksiniams ir nanostruktūrizuotiems LSMCO sluoksniams nustatyta fazinio virsmo temperatūra mažėja, didėjant kobalto kiekiui sluoksnyje. Taip pat, tiek epitaksiniams, tiek nanostruktūrizuotiems LSMCO sluoksniams buvo įvertinta ir kobalto kieko įtaką magnetovaržinėms savybėms, kadangi tai aktualu pažangesnių magnetinių jutiklių vystymui. Tiek struktūrinių, tiek elektrinių ir magnetinių tyrimų rezultatai parodė, kad cheminė sudėtis nulemia LSMCO sluoksnių savybes, todėl buvo lygintos LSMO (La1-xSrxMnzO3) ir LSMCO savybės. Struktūriniai, elektriniai ir magnetiniai tyrimai LSMO ir LSMCO sluoksniams atskleidė, kad epitaksinių sluoksnių pokyčiai priklauso nuo Mn kiekio, tuo tarpu nanostruktūrizuotų sluoksnių pokyčiai susiję su kobaltu. Šio darbo metu taip pat buvo sukurtas trijų sluoksnių grafeno ir LSMCO sluoksnio hibridinio jutiklio prototipas, kuris skirtas matuoti magnetinį lauką kambario temperatūroje plačiame magnetinio lauko diapazone (0,1–20 T).

1 January 2026 in IEEE Access
Verified
Journal Article
Open access
PPPavel Piatrou
Pavel Piatrou
VSVoitech Stankevic
Voitech Stankevic
SKSkirmantas Kersulis
Skirmantas Kersulis
VVVilius Vertelis
Vilius Vertelis
Elisabetta SieniElisabetta Sieni
Elisabetta Sieni
Nerija ZurauskieneNerija Zurauskiene
Nerija Zurauskiene