Skirmantas Kersulis

Dr. Skirmantas Kersulis

orcid

Research Focus & Metrics

Academic Career Length

14Years (2013-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
25 May 2022 in Sensors
Verified
Journal Article
Open access
PDF file
Nerija ZurauskieneNerija Zurauskiene
Nerija Zurauskiene
Voitech StankevicVoitech Stankevic
Voitech Stankevic
SKSkirmantas Kersulis
Skirmantas Kersulis
MVMilita Vagner
Milita Vagner
VPValentina Plausinaitiene
Valentina Plausinaitiene
AWAndrzej Wisniewski
Andrzej Wisniewski
The results of colossal magnetoresistance (CMR) properties of La1-xSrxMnyO3 (LSMO) films grown by the pulsed injection MOCVD technique onto an Al2O3 substrate are presented. The grown films with different Sr (0.05 ≤ x ≤ 0.3) and Mn excess (y > 1) concentrations were nanostructured with vertically aligned column-shaped crystallites spread perpendicular to the film plane. It was found that microstructure, resistivity, and magnetoresistive properties of the films strongly depend on the strontium and manganese concentration. All films (including low Sr content) exhibit a metal–insulator transition typical for manganites at a certain temperature, Tm. The Tm vs. Sr content dependence for films with a constant Mn amount has maxima that shift to lower Sr values with the increase in Mn excess in the films. Moreover, the higher the Mn excess concentration in the films, the higher the Tm value obtained. The highest Tm values (270 K) were observed for nanostructured LSMO films with x = 0.17–0.18 and y = 1.15, while the highest low-field magnetoresistance (0.8% at 50 mT) at room temperature (290 K) was achieved for x = 0.3 and y = 1.15. The obtained low-field MR values were relatively high in comparison to those published in the literature results for lanthanum manganite films prepared without additional insulating oxide phases. It can be caused by high Curie temperature (383 K), high saturation magnetization at room temperature (870 emu/cm3), and relatively thin grain boundaries. The obtained results allow to fabricate CMR sensors for low magnetic field measurement at room temperature.

1 June 2017 in Bioelectrochemistry
Verified
Journal Article
Closed access
PSPovilas Simonis
Povilas Simonis
SKSkirmantas Kersulis
Skirmantas Kersulis
VSVoitech Stankevich
Voitech Stankevich
VKVytautas Kašėta
Vytautas Kašėta
Eglė LastauskienėEglė Lastauskienė
Eglė Lastauskienė
Arunas StirkeArunas Stirke
Arunas Stirke

5 March 2020 in Symmetry
Verified
Journal Article
Open access
PDF file
Voitech StankevicVoitech Stankevic
Voitech Stankevic
PSPovilas Simonis
Povilas Simonis
Nerija ZurauskieneNerija Zurauskiene
Nerija Zurauskiene
Arunas StirkeArunas Stirke
Arunas Stirke
ADAldas Dervinis
Aldas Dervinis
SBSaulius Balevicius
Saulius Balevicius
The design and development of a compact square-wave pulse generator for the electroporation of biological cells is presented. This electroporator can generate square-wave pulses with durations from 3 μs up to 10 ms, voltage amplitudes up to 3500 V, and currents up to 250 A. The quantity of the accumulated energy is optimized by means of a variable capacitor bank. The pulse forming unit design uses a crowbar circuit, which gives better control of the pulse form and its duration, independent of the load impedance. In such cases, the square-wave pulse form ensures better control of electroporation efficiency by choosing parameters determined in advance. The device has an integrated graphic LCD screen and measurement modules for the visualization of the current pulse, allowing for express control of the electroporation quality and does not require an external oscilloscope for current pulse recording. This electroporator was tested on suspensions of Saccharomyces cerevisiae yeast cells, during which, it was demonstrated that the application of such square-wave pulses ensured better control of the electroporation efficiency and cell viability after treatment using the pulsed electric field (PEF).

4 March 2024 in Applied Sciences
Verified
Journal Article
Open access
PDF file
Liutauras MarcinauskasLiutauras Marcinauskas
Liutauras Marcinauskas
ŽKŽydrūnas Kavaliauskas
Žydrūnas Kavaliauskas
KJKamile Jonynaite
Kamile Jonynaite
RURolandas Uscila
Rolandas Uscila
MAMindaugas Aikas
Mindaugas Aikas
Voitech StankevicVoitech Stankevic
Voitech Stankevic
A gliding arc discharge (GAD) plasma device has been developed and tested. Possible applications areas for GAD plasma could be microalgae suspension treatments and the creation of plasma-activated water. To understand its behavior, the influence of the input power on the electrical characteristics of the generated GAD plasma was investigated using an oscilloscope. The waveforms of the voltage and current of GAD plasma are presented. The duration of the discharge time and the evolution of the arc during discharge were determined and investigated. It was revealed that the increase in the output voltage prolonged the duration of the arc discharge. The composition of the air plasma was investigated using a flame-emission spectrometer and acousto-optic emission spectrometer. It was revealed that the main species in the emission spectra of the GAD air plasma were N2, N2+, N+, NO, and O species. Furthermore, the increase in the input power enhanced the ionization degree of the air plasma and increased the intensities of the emission lines associated with N2+, NO, and O species. An increase in the conductivity of the BG-11 medium was observed. Physicochemical analyses of the plasma-activated BG-11 medium indicated an increase in the concentration of nitrite and nitrate ions and hydrogen peroxide with an enhancement of the voltage.

23 January 2019 in Beilstein Journal of Nanotechnology
Verified
Journal Article
Open access
PDF file
RDRasuole Lukose (prev. Dirsyte)
Rasuole Lukose (prev. Dirsyte)
VPValentina Plausinaitiene
Valentina Plausinaitiene
MVMilita Vagner
Milita Vagner
Nerija ZurauskieneNerija Zurauskiene
Nerija Zurauskiene
SKSkirmantas Kersulis
Skirmantas Kersulis
ENEvaldas Naujalis
Evaldas Naujalis
In the present study the advantageous pulsed-injection metal organic chemical vapour deposition (PI-MOCVD) technique was used for the growth of nanostructured La1−xSrxMnyO3±δ (LSMO) films on ceramic Al2O3 substrates. The compositional, structural and magnetoresistive properties of the nanostructured manganite were changed by variation of the processing conditions: precursor solution concentration, supply frequency and number of supply sources during the PI-MOCVD growth process. The results showed that the thick (≈400 nm) nanostructured LSMO films, grown using an additional supply source of precursor solution in an exponentially decreasing manner, exhibit the highest magnetoresistance and the lowest magnetoresistance anisotropy. The possibility to use these films for the development of magnetic field sensors operating at room temperature is discussed.

26 May 2017 in IEEE Transactions on Magnetics
Verified
Journal Article
Closed access
Nerija ZurauskieneNerija Zurauskiene
Nerija Zurauskiene
VRVakaris Rudokas
Vakaris Rudokas
SBSaulius Balevicius
Saulius Balevicius
SKSkirmantas Kersulis
Skirmantas Kersulis
VSVoitech Stankevic
Voitech Stankevic
RJRemigijus Juskenas
Remigijus Juskenas
The results of Co substitution for Mn in nanostructured La 1 -xSrxMn 1-y Co y O 3 films (x = 0.2) grown on polycrystalline Al 2 O 3 substrates by pulsed-injection metal-organic chemical vapor deposition technique, are presented. The Co content y in the films was changed as follows: 0; 0.023; 0.053; 0.078. The resistivity (p) dependences on temperature in zero magnetic field was investigated in the temperature range 5-300 K. It was found that the increase in Co content up to 0.078 results in the decrease of metal-insulator transition temperature and increase of the resistivity. The results of nanostructured films are compared with the epitaxial films grown on LaAlO 3 substrate keeping the same technological conditions. The magnetoresistance (MR) and MR anisotropy (MRA) were investigated at room temperature (290 K) in permanent magnetic fields up to 2.35 T, and pulsed magnetic fields up to 20 T. It was found that the highest MR values are obtained for the intermediate Co content: y = 0.053, while the MRA decreased with the increase of Co content. The results are discussed within the double-exchange interaction model for the perovskite oxides. The possibility to apply the manganite-cobaltite films for the development of room temperature B-scalar magnetic field sensors is considered.