12 September 2017 in Nature Biomedical Engineering
1 June 2022 in IEEE Solid-State Circuits Letters
This paper presents a novel bimodal, low-power, mm-scale transceiver for insertable smart pills. The proposed PA-less, 915 MHz uplink transmitter (TX) incorporates an 1.2×1.2 mm2 on-chip, non-resonated antenna as part of a current-starved ring oscillator (RO) and directly transmits data by turning the RO on/off. This RO-based uplink TX is implemented in 180 nm CMOS along with a power management unit, which generates all internal reference voltages and supplies from a single battery. The uplink TX achieves a data rate of 33 Mb/s and consumes 210 B5W, resulting in an energy efficiency of 6.4 pJ/bit. The orientation-insensitive magnetic field-based downlink receiver (RX) is implemented with an external 3-D magnetic sensor, achieves 0.02 kb/s of data rate limited by our measurement setup, and consumes 270 B5W. Wireless measurements in saline over 150 cm and prototype of the 3.2×13.6×2.3 mm3 insertable pill are presented.
12 September 2022 in IEEE Journal of Electromagnetics, RF and Microwaves in Medicine and Biology
Power transfer efficiency (PTE) and harmonics are crucial performance parameters of the resonant rectifier design for low/medium coupling inductive wireless power transfer (WPT) systems used in wireless biomedical implants. The performance of a resonant rectifier degrades under higher loading and lower coupling conditions as the voltage available to the rectifier at the output of the receiver coil becomes low. As the diode turn-on impedance increases, diodes turn on incompletely, leading to non-linearities that reduce rectifier efficiency and output voltage. This work proposes a new rectifier design to increase efficiency and reduce harmonics by decreasing the diode turn-on impedance compared to traditional rectifier designs, such as resonant Half Wave Rectifier (HWR). The proposed rectifier design offers individual paths for RF and rectification signals, which reduces the non-linear loading on the receiver coil and improves diode turn-on performance. Measurement and SPICE simulation results show efficiency enhancement of 50% and reduction of harmonics by 6 dB for the proposed rectifier compared to HWR.
18 November 2025 in Journal of Neural Engineering
Objective. Investigation into complex neural circuits necessitates interfaces capable of high channel count recording and stimulation. However, existing commercial neural headstages often have limited scalability, restrictive proprietary designs, and constrained bidirectional capabilities, which worsens accessibility challenges and compels researchers to reinvent tools rather than build on a shared foundation. Approach. Here, we present two open-source, 128 channel headstages—Iris 128B and Iris 128S—designed for integration with microelectrode arrays. The Iris 128B enables fully bidirectional interfacing, with stimulation or recording across all 128 electrode channels, while the Iris 128S provides recording on 128 channels and stimulation on 16 simultaneous channels, which can be assigned to any 16 of the 32 available stimulation channels. Both designs use Intan Technologies’ RHS and RHD series integrated circuits for amplification, filtering, digitization and stimulation, and are available on GitHub. Main results. The headstages were validated through benchtop impedance, noise, and frequency response measurements, as well as acute in vivo recordings in an anesthetized rat. Results demonstrate low noise levels and reliable signal acquisition across all channels. Significance. By releasing fully documented printed circuit board designs for headstages, this work aims to take a step towards broader adoption of bidirectional recording and stimulation systems while increasing channel counts. Future iterations will focus on miniaturization and wireless integration to improve usability in chronic and freely moving small animal experiments.