Johan Hagberg

Johan Hagberg

Auto-generated profile, based on publicly available information

Johan Hagberg

Division of Applied Electrochemistry, Department of Chemical Engineering, KTH Royal Institute of Technology, SE-100 44, Stockholm, Sweden

Research Focus & Metrics

Academic Career Length

12Years (2015-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 July 2018 in Composites Science and Technology
Verified
Journal Article
Closed access
JHJohan Hagberg
Johan Hagberg
HMHenry A. Maples
Henry A. Maples
KAKayne S.P. Alvim
Kayne S.P. Alvim
JXJohanna Xu
Johanna Xu
WJWilhelm Johannisson
Wilhelm Johannisson
GLGöran Lindbergh
Göran Lindbergh

27 May 2016 in Journal of the Electrochemical Society
Verified
Journal Article
Open access
PDF file
JHJohan Hagberg
Johan Hagberg
SLSimon Leijonmarck
Simon Leijonmarck
GLGöran Lindbergh
Göran Lindbergh
Carbon fibers have the combined mechanical and electrochemical properties needed to make them particularly well suited for usage as electrodes in a structural lithium-ion battery, a material that simultaneously works as a battery and a structural composite. Presented in this paper is an evaluation of commercial polyacrylonitrile-based carbon fibers in terms of capacity and coulombic efficiency, as well as a microstructural and surface evaluation. Some polyacrylonitrile based carbon fibers intercalate lithium ions, resulting in a similar capacity as state-of-the-art graphite based electrodes, presently the most commonly used negative electrode material. Using high precision coulometry, we found a capacity of around 250–350 mAh/g and a very high coulombic efficiency of over 99.9% after ten cycles, which is even higher than a commercial state-of-the art graphitic electrode evaluated as reference. The high coulombic efficiency is attributed to the very low surface area of the carbon fibers, resulting in a small and stable solid-electrolyte interface layer. A highly graphitized ultra high modulus carbon fiber was evaluated as well and, compared to the other fibers, less lithium was inserted (corresponding to approximately 150 mAh/g). We show that the use of carbon fibers as an electrode material in a structural composite battery is indeed viable.

13 September 2017 in Holzforschung
Verified
Journal Article
Closed access
PDF file
Andrzej NowakAndrzej Nowak
Andrzej Nowak
JHJohan Hagberg
Johan Hagberg
SLSimon Leijonmarck
Simon Leijonmarck
HSHannah Schweinebarth
Hannah Schweinebarth
DBDarren Baker
Darren Baker
GLGöran Lindbergh
Göran Lindbergh
Lignin-based carbon fibers (LCFs) from the renewable resource softwood kraft lignin were synthesized via oxidative thermostabilization of pure melt-spun lignin and carbonization at different temperatures from 1000°C to 1700°C. The resulting LCFs were characterized by tensile testing, scanning electron microscopy (SEM), X-ray diffraction (XRD) and confocal Raman spectroscopy. The microstructure is mainly amorphous carbon with some nanocrystalline domains. The strength and stiffness are inversely proportional to the carbonization temperature, while the LCFs carbonized at 1000°C exhibit a strength of 628 MPa and a stiffness of 37 GPa. Furthermore, the application potential of LCFs was evaluated as negative electrodes in a lithium-ion battery (LIB) by electrochemical cycling at different current rates in a half-cell setup. The capacity drops with the carbonization temperature and the LCFs carbonized at 1000°C have a capacity of 335 mAh g−1. All LCFs showed good cycling stability. Because of the mechanical integrity and conductivity of the LCFs, there is no need to apply current collectors, conductive additives or binders. The advantage is an increased gravimetric energy density compared to graphite, which is the most common negative electrode material. LCFs show a promising multifunctional behavior, including good mechanical integrity, conductivity and an ability to intercalate lithium for LIBs.

25 June 2015 in Physical Chemistry Chemical Physics
Verified
Journal Article
Open access
PDF file
BWBjorn Wickman
Bjorn Wickman
MFMattias Fredriksson
Mattias Fredriksson
LFLigang Feng
Ligang Feng
NLNiklas Lindahl
Niklas Lindahl
JHJohan Hagberg
Johan Hagberg
CLChristoph Langhammer
Christoph Langhammer
We demonstrate a flexible combined electrochemistry and fiber optics-based in situ UV/vis spectroscopy setup to gain insight into the depth evolution of electrochemical hydride and oxide formation in Pd films with thicknesses of 20 and 100 nm. The thicknesses of our model systems are chosen such that the films are thinner or significantly thicker than the optical skin depth of Pd to create two distinctly different situations. Low power white light is irradiated on the sample and analyzed in three different configurations; transmittance through, and, reflectance from the front and the back side of the film. The obtained optical sensitivities correspond to fractions of a monolayer of adsorbed or absorbed hydrogen (H) and oxygen (O) on Pd. Moreover, a combined simultaneous readout obtained from the different optical measurement configurations provides mechanistic insights into the depth-evolution of the studied hydrogenation and oxidation processes.

2 April 2018 in Batteries
Verified
Journal Article
Open access
PDF file
HLHuiran Lu
Huiran Lu
JHJohan Hagberg
Johan Hagberg
GLGöran Lindbergh
Göran Lindbergh
ACAnn Cornell
Ann Cornell
Flexible, low-weight electrodes with integrated current collectors based on chopped polyacrylonitrile carbon fibers (CF) were produced using an easy, aqueous fabrication process, where only 4 wt% of TEMPO-oxidized cellulose nanofibrils (CNF) were used as the binder. A flexible full cell was assembled based on a LiFePO4 (LFP) positive electrode with a CF current collector and a current collector-free CF negative electrode. The cell exhibited a stable specific capacity of 121 mAh g−1 based on the LFP weight. The CF in the negative electrode acted simultaneously as active material and current collector, which has a significant positive impact on energy density. Stable specific capacities of the CF/CNF negative electrode of 267 mAh g−1 at 0.1 C and 150 mAh g−1 at 1 C are demonstrated. The LFP/CNF with CF/CNF, as the current collector positive electrode (LFP-CF), exhibited a good rate performance with a capacity of ~150 mAh g−1 at 0.1 C and 133 mAh g−1 at 1 C. The polarization of the LFP-CF electrode was similar to that of a commercial Quallion LFP electrode, while much lower compared to a flexible LFP/CNF electrode with Al foil as the current collector. This is ascribed to good contact between the CF and the active material.

24 March 2022 in Journal of Materials Chemistry A
Verified
Journal Article
Open access
PDF file
YFYuan Fang
Yuan Fang
KPKevin Peuvot
Kevin Peuvot
AGAlice Gratrex
Alice Gratrex
EMEvgeny V. Morozov
Evgeny V. Morozov
JHJohan Hagberg
Johan Hagberg
IFIstván Furó
István Furó
The storage mechanism of lithium in hard carbon was investigated by 7 Li NMR and 2D-XRD methods. Lithium was found to fill disordered sites first and then fill the ordered sites of graphitic character arranged in a distinct mesoscopic order.