Tenghao Zou

Tenghao Zou

Auto-generated profile, based on publicly available information

Tenghao Zou

State Key Laboratory of Integrated Chip and Systems, Institute of Microelectronics, Fudan University, Shanghai, China

Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
16 February 2023 in IEEE Journal of Solid-State Circuits
Verified
Journal Article
Closed access
YWYizhuo Wang
Yizhuo Wang
JSJiahe Shi
Jiahe Shi
HXHao Xu
Hao Xu
SJShujiang Ji
Shujiang Ji
YMYiyun Mao
Yiyun Mao
NYNa Yan
Na Yan
This article presents a wideband, low-jitter frequency synthesizer utilizing a dual-mode voltage-controlled oscillator (VCO). Mode imbalance in the dual-mode VCO is analyzed theoretically and compensated through the proposed symmetric figure-8 transformer and capacitor arrays. The compact mode-switching circuitry fundamentally eliminates mode ambiguity in multi-mode autonomous circuits. A computer-aided algorithm based on sequential least-squares programming (SLSQP) and hierarchical optimization method is developed to automatically optimize the capacitor array in the wideband VCO. The implemented dual-mode VCO suppresses the phase noise (PN) difference across the operating frequency range, which further enables a sub-sampling phase-locked loop (SSPLL) to achieve near-minimum jitter across a wide frequency range without loop gain adaptation. Fabricated in a 40-nm CMOS process, the wideband SSPLL covers the frequency range of 7.9–14.3 GHz with 14.1–17.2-mW power consumption and occupies only 0.18-mm $^2$ area. The SSPLL achieves better than $-$ 115-dBc/Hz in-band PN at a 10-GHz carrier. The rms jitter is less than 85 fs across the whole frequency range. The corresponding figure-of-merit tuning (FoM $_T$ ) is $-$ 247.1 to $-$ 248.1 dB.

2 May 2023 in IEEE Transactions on Circuits and Systems I: Regular Papers
Verified
Journal Article
Closed access
TZTenghao Zou
Tenghao Zou
HXHao Xu
Hao Xu
YWYizhuo Wang
Yizhuo Wang
WLWeitian Liu
Weitian Liu
THTingting Han
Tingting Han
NYNa Yan
Na Yan
This paper presents a wideband 6-12GHz two-stage low noise amplifier (LNA) that utilizes capacitor assisting triple-winding transformer in the inter-stage matching network. The electric coupling introduced by the assisting capacitor expands the design space by allowing independent control of each effective coupling strength of the three coupled inductors. The equivalent negative resistor enhanced by this capacitor improves the quality factor of the inter-stage network at high frequencies, which further improves the overall design trade-off among gain, bandwidth and noise figure. Fabricated in a 130nm SOI CMOS process, the LNA achieves a remarkable 0.8-1.5dB NF, $<$ -14dB S11, $<$ -8dB S22, -11.8dBm IP $_{\bf {1dB}}$ and 21.8-23.3dB power gain across the 6-12GHz passband with $\pm$ 0.75dB ripple while drawing 20mA from a 3.3V supply.

24 December 2024 in IEEE Journal of Solid-State Circuits
Verified
Journal Article
Closed access
JBJunyan Bi
Junyan Bi
HXHao Xu
Hao Xu
TZTenghao Zou
Tenghao Zou
YZYaxin Zeng
Yaxin Zeng
YTYechen Tian
Yechen Tian
NYNa Yan
Na Yan
A wideband reconfigurable quadrature receiver with the range of 5–18-GHz frequency coverage and 100–500-MHz analog baseband bandwidth is proposed in this article. The low-noise front end utilizes a capacitor assisting triple-winding transformer (CTTF) to expand bandwidth and suppress noise. An injection-locked oscillator driven by a delay-locked loop is used to generate the quadrature clocks without using the divider and the associated high-frequency clock. The hybrid baseband filter consisting of passive RLC and active-RC biquad simultaneously achieves high linearity and flexible gain/bandwidth adjustments. The analog baseband circuitry employs a feedforward compensated transconductance amplifier that greatly relaxes the power-bandwidth trade-off. To mitigate the impact of complex and frequency-dependent quadrature error (I–Q mismatch) arising from I-to-Q clock overlap, the receiver applies separate RF- $G_{m}$ to drive I and Q passive mixers. Fabricated in a 28-nm CMOS process, the proposed receiver exhibits a noise figure of 2.1–5.4-dB and 30–72-dB adjustable conversion gain, >20-dBm in-band OIP3, >16-dBm out-of-band OIP3 with a total power consumption of 104–199-mW at 1-V supply.

1 January 2026 in IEEE Transactions on Circuits and Systems II: Express Briefs
Verified
Journal Article
Closed access
TZTenghao Zou
Tenghao Zou
HXHao Xu
Hao Xu
NYNa Yan
Na Yan