Shujiang Ji

Shujiang Ji

Auto-generated profile, based on publicly available information

Shujiang Ji

State Key Laboratory of Integrated Chip and Systems, Institute of Microelectronics, Fudan University, Shanghai, China

Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
16 February 2023 in IEEE Journal of Solid-State Circuits
Verified
Journal Article
Closed access
YWYizhuo Wang
Yizhuo Wang
JSJiahe Shi
Jiahe Shi
HXHao Xu
Hao Xu
SJShujiang Ji
Shujiang Ji
YMYiyun Mao
Yiyun Mao
NYNa Yan
Na Yan
This article presents a wideband, low-jitter frequency synthesizer utilizing a dual-mode voltage-controlled oscillator (VCO). Mode imbalance in the dual-mode VCO is analyzed theoretically and compensated through the proposed symmetric figure-8 transformer and capacitor arrays. The compact mode-switching circuitry fundamentally eliminates mode ambiguity in multi-mode autonomous circuits. A computer-aided algorithm based on sequential least-squares programming (SLSQP) and hierarchical optimization method is developed to automatically optimize the capacitor array in the wideband VCO. The implemented dual-mode VCO suppresses the phase noise (PN) difference across the operating frequency range, which further enables a sub-sampling phase-locked loop (SSPLL) to achieve near-minimum jitter across a wide frequency range without loop gain adaptation. Fabricated in a 40-nm CMOS process, the wideband SSPLL covers the frequency range of 7.9–14.3 GHz with 14.1–17.2-mW power consumption and occupies only 0.18-mm $^2$ area. The SSPLL achieves better than $-$ 115-dBc/Hz in-band PN at a 10-GHz carrier. The rms jitter is less than 85 fs across the whole frequency range. The corresponding figure-of-merit tuning (FoM $_T$ ) is $-$ 247.1 to $-$ 248.1 dB.

28 February 2022 in IEEE Microwave and Wireless Components Letters
Verified
Journal Article
Closed access
SJShujiang Ji
Shujiang Ji
YWYizhuo Wang
Yizhuo Wang
YZYuxiao Zhao
Yuxiao Zhao
HGHaoyuan Gao
Haoyuan Gao
YMYiyun Mao
Yiyun Mao
NYNa Yan
Na Yan
A sub-sampling PLL (SSPLL) employing an adaptive frequency-locked loop (FLL) without static power consumption is proposed in this letter. A new unlock detection mechanism and a configurable PFD are realized in the adaptive FLL. With the new unlock detection mechanism, while the FLL that contains phase detector, divider, and charge pump dissipates no power during the locked steady state, it automatically starts when external interferences disturb the locked state. The optimized dead zone in the configurable PFD ensures a rapid relocking operation. Based on the proposed adaptive FLL, the 2.4 GHz SSPLL is fabricated in a 40-nm CMOS process. It achieves −128.5 dBc/Hz at 1 MHz offset frequency and the rms jitter is 103.58 fs integrated from 10 k to 10 MHz. It consumes 1.55 mW at 1 V supply and achieves −257.8 dB FOM.

3 April 2024 in IEEE Transactions on Circuits and Systems I: Regular Papers
Verified
Journal Article
Closed access
HXHao Xu
Hao Xu
SJShujiang Ji
Shujiang Ji
YWYizhuo Wang
Yizhuo Wang
XLXinyi Lin
Xinyi Lin
HMHao Min
Hao Min
NYNa Yan
Na Yan
This paper presents an analog low-power sub-sampling phase locked loop (PLL) that tackles the reference spur caused by VCO load modulation from the sub-sampling operation. A complete analysis on the binary frequency shift keying (BFSK) effect including the impact of the VCO buffer is provided, followed by practical design guide that achieves the optimum spur/jitter trade-off. The proposed sub-sampling phase detector incorporates an active primary-secondary architecture for improved isolation to suppress the load modulation. The adaptive frequency locked loop (FLL) consumes zero power in the locked state and activates itself once unlocking is detected. The sub-sampling PLL is fabricated in a 40nm CMOS process. It achieves -121.5dBc/Hz phase noise at 1MHz offset frequency and an RMS jitter of 185fs integrated from 10k to 10MHz. The power dissipation is 1.14mW at 0.95V supply with a -254.1dB figure-of-merit. The proposed phase detector results in -73dBc reference spur that is among the lowest in state-of-art works.

6 June 2022 in IEEE Internet of Things Journal
Verified
Journal Article
Closed access
KTKuanfeng Tang
Kuanfeng Tang
MWMaodong Wang
Maodong Wang
MLMeng Liu
Meng Liu
CZChao Zhang
Chao Zhang
SXShengliang Xu
Shengliang Xu
JMJin Mitsugi
Jin Mitsugi
This paper introduces a highly integrated passive wireless sensing system based on extended EPC Gen2 protocol, using sensor tags and a reader to support concurrent data streams from multiple sensors. Multiple Subcarrier Multiple Access (MSMA) is used by assigning different subcarrier frequencies to the sensor tags for backscattering so that each tag has an independent channel for communication to achieve the simultaneous streaming of multi-sensor data. In order to improve the subcarrier frequency accuracy and further increase the number of communication channels, this paper proposes a novel method of subcarrier frequency calibration based on the Gen2 protocol. This method enables a high accuracy clock to be generated on-chip. At the same time, this paper also proposes a method based on Gen2 protocol to start a group of tags and receive real-time data in parallel. The tag chip is fabricated in a 0.18 μm CMOS process with a die size of 850 μm × 850 μm, and the reader prototype is built using software-defined radio equipment. The test results show that the sensing system proposed in this paper can collect and recognize concurrent data streams from multiple sensor tags synchronously. The measured sensitivity of the sensor tag is -14.9dBm with a 3-axis accelerating sensor, and the calibration accuracy of subcarrier frequency is better than ±0.385KHz in the range of 40KHz-640KHz. With this accuracy, the tags can be allocated up to 78 subcarrier communication channels theoretically.