Thin film Cu(In,Ga)Se2 solar cells with ALD-deposited Zn1-xSnxOy buffer layers were fabricated and the solar cell properties were investigated for varying ALD deposition temperatures in the range from 90 °C up to 180 °C. It was found that a process window exists between 105 °C and 135 °C, where high solar cell efficiency can be achieved. At lower ALD deposition temperatures the solar cell performance was mainly limited by low fill factor and at higher temperatures by low open circuit voltage. Numerical simulations and electrical characterization were used to relate the changes in solar cell performance as a function of ALD deposition temperature to changes in the conduction band energy level of the Zn1-xSnxOy buffer layer. The Zn1-xSnxOy films contain small ZnO or ZnO(Sn) crystallites (~10 nm), resulting in quantum confinement effects influencing the optical band gap of the buffer layer. The ALD deposition temperature affects the size of these crystallites and it is concluded that most of the changes in the band gap occur in the conduction band level
Designing heterostructure materials at the nanoscale is a well-known method to enhance gas sensing performance. In this study, a mixed solution of zinc chloride and tin (II) chloride dihydrate, dissolved in ethanol solvent, was used as the initial precursor for depositing the sensing layer on alumina substrates using the ultrasonic spray pyrolysis (USP) method. Several ZnO/SnO2 heterostructures were grown by applying different ratios in the initial precursors. These heterostructures were used as active materials for the sensing of H2S gas molecules. The results revealed that an increase in the zinc chloride in the USP precursor alters the H2S sensitivity of the sensor. The optimal working temperature was found to be 450 °C. The sensor, containing 5:1 (ZnCl2: SnCl2·2H2O) ratio in the USP precursor, demonstrates a higher response than the pure SnO2 (∼95 times) sample and other heterostructures. Later, the selectivity of the ZnO/SnO2 heterostructures toward 5 ppm NO2, 200 ppm methanol, and 100 ppm of CH4, acetone, and ethanol was also examined. The gas sensing mechanism of the ZnO/SnO2 was analyzed and the remarkably enhanced gas-sensing performance was mainly attributed to the heterostructure formation between ZnO and SnO2. The synthesized materials were also analyzed by X-ray diffraction, scanning electron microscopy, energy-dispersive X-ray, transmission electron microscopy, and X-ray photoelectron spectra to investigate the material distribution, grain size, and material quality of ZnO/SnO2 heterostructures.
8 October 2011 in Progress in Photovoltaics: Research and Applications