Syed Hasan

Syed Hasan

Auto-generated profile, based on publicly available information

Syed Hasan

National Renewable Energy Laboratory , Golden, Colorado 80401

Research Focus & Metrics

Academic Career Length

14Years (2013-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 October 2013 in Advances in Materials Science and Engineering
Verified
Journal Article
Open access
PDF file
SHS I Hossain
S I Hossain
NHNazmul Hasan
Nazmul Hasan
AHAzman Hassan
Azman Hassan
In present research, natural fiber obtained from ladies finger plant was chemically treated separately using alkali (2% NaOH), chromium sulfate (4% ), and chromium sulfate and sodium bicarbonate (4% ). Both raw and chemically treated fibers were subsequently characterized using mechanical (tensile), structural (Fourier transform infrared spectroscopy and scanning electron microscopy), and thermal (thermogravimetric) analysis. Fourier analysis showed the presence of (OH) group in the ladies plant fiber. Scanning electron micrographs revealed rougher surface in case of alkali treated fiber, while thin coating layer was formed on the fiber surface during other two treatments. Tensile test on ladies finger single fiber was carried out by varying span length. The tensile strength and Young's modulus values were found to be increased after chemical treatment. For both raw and chemically treated fibers, Young's modulus increased and tensile strength decreased with increase in span length. Thermogravimetric analysis indicated the same level of thermal stability for both raw and treated ladies finger fibers.

1 February 2024 in AIP Advances
Verified
Journal Article
Open access
PDF file
AGArnob Ghosh
Arnob Ghosh
KKKamruzzaman Khan
Kamruzzaman Khan
SSShrivatch Sankar
Shrivatch Sankar
ZJZhe (Ashley) Jian
Zhe (Ashley) Jian
SHSyed M. N. Hasan
Syed M. N. Hasan
SAShamsul Arafin
Shamsul Arafin
In this paper, we report the molecular beam epitaxy-grown InGaN-quantum disks embedded within selective area epitaxy of GaN nanowires with both Ga- and N-polarities. A detailed comparative analysis of these two types of nanostructures is also provided. Compared to Ga-polar nanowires, N-polar nanowires are found to exhibit a higher vertical growth rate, flatter top, and reduced lateral overgrowth. InGaN quantum disk-related optical emission is observed from nanowires with both polarities; however, the N-polar structures inherently emit at longer wavelengths due to higher indium incorporation. Considering that N-polar nanowires offer more compelling geometry control compared to Ga-polar ones, we focus on the theoretical analysis of only N-polar structures to realize high-performance quantum emitters. A single nanowire-level analysis was performed, and the effects of nanowire diameter, taper length, and angle on guided modes, light extraction, and far-field emission were investigated. These findings highlight the importance of tailoring nanowire geometry and eventually optimizing the growth processes of III-nitride nanostructures.

21 October 2024 in Applied Physics Letters
Verified
Journal Article
Open access
PDF file
SSStephen Schaefer
Stephen Schaefer
MSMichelle A. Smeaton
Michelle A. Smeaton
KEKingsley Egbo
Kingsley Egbo
SHSyed Hasan
Syed Hasan
WCWilliam Callahan
William Callahan
MTMarshall Tellekamp
Marshall Tellekamp
We have epitaxially stabilized a series of monoclinic (AlxGa1−x−yIny)2O3 alloys by careful choice of molecular beam epitaxy growth conditions, which balance alloy growth with suboxide desorption. The films are pseudomorphic to (010) β-Ga2O3 substrates at thicknesses up to 150 nm with compositions ranging from (Al0.01Ga0.83In0.16)2O3 to (Al0.24Ga0.75In0.03)2O3. The absorption edge shifts from approximately 4.62–5.14 eV with coincidently increasing Al and decreasing In mole fractions. J–V measurements reveal an increase in resistivity over four orders of magnitude with a maximum value of 4.2 × 105 Ω-cm for (Al0.17Ga0.76In0.07)2O3, which has nearly identical lattice parameters (both in-plane and out-of-plane) to the underlying β-Ga2O3. Scanning transmission electron microscopy of this sample reveals a mostly uniform and single crystalline film, though we identify areas of non-uniform In incorporation and some γ-phase inclusions. This work demonstrates the feasibility of thick layers lattice-matched to β-Ga2O3 with increased bandgap compared to phase-separation limited (Al,Ga)2O3. These alloys can enable higher bandgap epitaxial dielectrics and high sheet charge density transistors by increasing the conduction band offset with respect to β-Ga2O3.

10 February 2025 in Applied Physics Letters
Verified
Journal Article
Closed access
SSStephen Schaefer
Stephen Schaefer
MSMichelle A. Smeaton
Michelle A. Smeaton
KEKingsley Egbo
Kingsley Egbo
SHSyed Hasan
Syed Hasan
WCWilliam Callahan
William Callahan
MTMarshall Tellekamp
Marshall Tellekamp