Realizing intrinsically stretchable transistors with high current drivability, high mobility, small feature size, low power and the potential for mass production is essential for advancing stretchable electronics a critical step forward. However, it is challenging to realize these requirements simultaneously due to the limitations of the existing fabrication technologies when integrating intrinsically stretchable materials into transistors. Here, we propose a removal-transfer-photolithography method (RTPM), combined with adopting poly(urea-urethane) (PUU) as a dielectric, to realize integratable intrinsically stretchable carbon nanotube thin-film transistors (IIS-CNT-TFTs). The realized IIS-CNT-TFTs achieve excellent electrical and mechanical properties simultaneously, showing high field-effect-mobility up to 221 cm2 V−1 s−1 and high current density up to 810 μA mm−1 at a low driving voltage of −1 V, which are both the highest values for intrinsically stretchable transistors today to the best of our knowledge. At the same time, the transistors can survive 2000 cycles of repeated stretching by 50%, indicating their promising applicability to stretchable circuits, displays, and wearable electronics. The achieved intrinsically stretchable thin-film transistors show higher electrical performance, higher stretching durability, and smaller feature size simultaneously compared with the state-of-the-art works, providing a novel solution to integratable intrinsically stretchable electronics. Besides, the proposed RTPM involves adopting removable sacrificial layers to protect the PDMS substrate and PUU dielectric during the photolithography and patterning steps, and finally removing the sacrificial layers to improve the electrical and mechanical performance. This method is generally applicable to further enhance the performance of the existing transistors and devices with a similar structure in soft electronics.
Amorphous indium gallium zinc oxide (a-IGZO) thin film transistors (TFTs) with high mobility are highly desirable to achieve high-speed operation in active-matrix displays and largearea sensors. Only a few works provided potential solutions. In this work, we have embedded carbon nanotubes (CNTs) into sputtered a-IGZO film to form a-IGZO/CNT/a-IGZO (ACA) sandwiched channel. In the ACA channel, the CNT percolation networks connected by the a-IGZO film work as high-speed carrier paths to enable faster transport of carriers during the on state while it does not degrade the leakage performance during the off state. The type and the embedding location of the CNT percolation network are critical to determine the ACA device performance, which is analyzed and verified by experiment and simulation. The optimum ACA design has approximately doubled the mobility and the on current density of the TFT. The design owns relatively better uniformity and provides a high-speed TFT solution for the advanced electronics.